🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN 302-6:2023

BS EN 302-6:2023

$86.31

Adhesives for load-bearing timber structures. Test methods – Determination of the minimum pressing time under referenced conditions

Published By Publication Date Number of Pages
BSI 2023 14
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This document specifies a method of determining the minimum pressing time for two glue line thicknesses, close contact glue line and thick glue line (between 0,3 mm and 8 mm), at three temperatures. It is applicable to adhesives used in load-bearing timber products. This document is only intended for obtaining a reliable base of comparison of pressing time between adhesives. The method gives results that cannot be applied to the safe manufacture of timber structures without modifications for the influences of timber density/absorbency, moisture content, factory temperature and relative air humidity.

PDF Catalog

PDF Pages PDF Title
2 undefined
8 1 Scope
2 Normative references
3 Terms and definitions
9 4 Symbols
5 Principle
6 Apparatus
10 7 Procedure
7.1 General
7.2 Preparation of bonded assemblies
7.3 Preparation of test specimens
7.4 Test procedure
11 8 Expression of results
8.1 Tensile shear strength
8.2 Failure mode
9 Calculation of minimum pressing time
10 Test report
10.1 Adhesives
10.2 Preparation of test pieces and testing procedure
12 10.3 Test results

Related products

BS EN 302-6:2023
$86.31