BS ISO 16630:2017
$102.76
Metallic materials. Sheet and strip. Hole expanding test
| Published By | Publication Date | Number of Pages |
| BSI | 2017 | 16 |
This document describes a method of determining the hole expansion ratio in metallic sheets and strips with a thickness range of 1,2 mm to 6,0 mm inclusive and a width of at least 90 mm.
NOTE This test is normally applicable to sheet metal and is used to assess the suitability of the product for forming flanges.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions 4 Symbols and designations |
| 10 | 5 Principle |
| 11 | 6 Apparatus 7 Test piece |
| 13 | 8 Test procedure |
| 14 | 9 Calculation of test data |
| 15 | 10 Test report |
