TIA-455-187:1991

$19.50

FOTP-187 Engagement and Separation Force Measurement of Fiber Optic Connector Sets

Published By	Publication Date	Number of Pages
TIA	1991	12

Guaranteed Safe Checkout

Category: TIA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

INTRODUCTION

Intent

The purpose of this procedure is to measure the forces or
torques that are required to fully couple or uncouple a connector
set.

Description

The connector set components are held in a fixture so that a
controlled coupling force or torque can be applied. The force or
torque is measured during the entire coupling and/or uncoupling
cycle. The procedure is applicable to either twist type or
push-pull type coupling mechanisms.

Alternative Procedures

This test procedure is an alternative to the measurement
procedure, titled Engagement and Separation Force of IEC 874-1,
Third Edition.

Additional information