AWWA C221 2007

$75.83

AWWA C221-07: Fabricated Steel Mechanical Slip Type Expansion Joints

Published By	Publication Date	Number of Pages
AWWA	2007	28

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard describes fabricated steel mechanical slip-type expansion joints having packing chambers for use on pipe with plain, flanged, grooved, or shouldered ends in nominal pipe sizes from 3 in. (75 mm) through 144 in. (3,600 mm). The joints shall be manufactured from steel and are intended for use in systems conveying water. Mechanical expansion joints are not intended for use in buried conditions.

PDF Catalog

PDF Pages	PDF Title
1	ANSI/AWWA C221-07
3	Committee Personnel
7	Contents
9	Foreword I. Introduction.
10	II. Special Issues. III. Use of This Standard.
12	IV. Major Revisions. V. Comments.
13	AWWA Standard Fabricated Steel Mechanical Slip-Type Expansion Joints SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose
14	Sec. 1.3 Application SECTION 2: REFERENCES
16	SECTION 3: DEFINITIONS
18	SECTION 4: REQUIREMENTS Sec. 4.1 Materials of Construction
19	Table 1 Minimum physical properties of elastomeric packing
20	Table 2 Pipe-end diameter tolerance Sec. 4.2 Design
23	Sec. 4.3 Fabrication
24	Sec. 4.4 Coatings Sec. 4.5 Installation Instructions
25	SECTION 5: VERIFICATION Sec. 5.1 Inspection Sec. 5.2 Quality Assurance Sec. 5.3 Test Procedures
26	Sec. 5.4 Nonconformance SECTION 6: DELIVERY Sec. 6.1 Marking
27	Sec. 6.2 Packaging and Shipping Sec. 6.3 Affidavit of Compliance