🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
AGMA 05FTM19:2005 Edition

AGMA 05FTM19:2005 Edition

$14.30

The Application of Very Large, Weld Fabricated, Carburized, Hardened & Hard Finished Advanced Technology Gears in Steel Mill Gear Drives

Published By Publication Date Number of Pages
AGMA 2005 18
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Authors: Raymond Drago, Roy Cunningham, Steve Cymbala, Drive Systems Technology, Inc.

In the 1980's, Advanced TechnologyGear (ATG) steel rollingmill gear drives consisting of carburized pinions

in mesh with very large, weld fabricated, high through hardened gears were introduced to improve capacity.

Recently, even the improvements obtained from these ATG gear sets were not sufficient to meet higher

production rates and rolling loads. For greater load capacity ATG sets have been developed consisting of

carburized, hardened pinions in mesh with very large, weld fabricated, carburized and hard finished gears.

Single and double helical gears of this type, ranging in size from 80 to 136 inches pitch diameter have been

implemented in several steel rolling applications. This paper describes the conditions that require the use of

these gears and the technology required to design, manufacture, and, especially, heat treat, these very

special, very large gear sets.

Related products

AGMA 05FTM19
$14.30