AS 2898.1:2003
$33.80
Radar speed detection – Functional requirements and definitions
Published By | Publication Date | Number of Pages |
AS | 2003-08-11 | 17 |
If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]
Specifies functional requirements for radar devices which are used to measure the speed of target vehicles for law enforcement or scientific measurement.
Scope
This Standard specifies functional requirements for radar devices which are used to measure the speed of targets for law enforcement or for scientific measurement. This Standard applies to both direct doppler radar devices (Types I and II) and slant doppler radar devices (Types III and IV), including devices linked to an image capture system.
Published Code | AS |
---|---|
Published By | Australia Standards |
Publication Date | 2003-08-11 |
Pages Count | 17 |
Language | English |
Edition | 3 |
File Size | 419.8 KB |
ISBN | 0733754600 |
ICS Codes | 03.160 - Law. Administration 93.080.30 - Road equipment and installations |
Related products
-
AS 4848.1:2006
Application specifications for coating systems – Single coat inorganic (ethyl) zinc silicate – Solvent-borne Published…
-
AS 1988.1:2006
Welding of ferrous castings – Steel castings Published By Publication Date Number of Pages AS…
-
AS 2888.11:2002 (R2017)
Methods of testing plastics waste fittings – Method for cyclic testing of plastics telescopic waste…
-
AS/NZS 60898.1:2004
Electrical accessories – Circuit-breakers for overcurrent protection for household and similar installations – Circuit-breakers for…
-
AS 2879.1:2000
Alumina – Determination of loss of mass at 300 degrees Celsius and 1000 degrees Celsius…
-
IEEE 2888.1-2023
IEEE Standard for Specification of Sensor Interface for Cyber and Physical Worlds (Published) Published By…
-
IEEE 1888.1-2013
IEEE Standard for Ubiquitous Green Community Control Network: Control and Management Published By Publication Date…
-
AS 2986.1:2003 (R2016)
Workplace air quality – Sampling and anlysis of volatile organic compounds by solvent desorption/gas chromatography…
-
AS 2888.9:2002 (R2017)
Methods of testing plastics waste fittings – Method for determining residual stress in plastics waste…
-
AS 4868.1:2008
Copper, lead and zinc sulfide concentrates – Chemical analysis – Determination of gold and silver…
-
AS 2888.5:2002 (R2017)
Methods of testing plastics waste fittings – Trap seal test Published By Publication Date Number…
-
AS 2898.2:2003
Radar speed detection – Operational procedures Published By Publication Date Number of Pages AS 2003-08-11…
-
AS 3891.1:2008
Air navigation – Cables and their supporting structures – Marking and safety requirements – Permanent…
-
AS 2888.4:2002 (R2017)
Methods of testing plastics waste fittings – Method for air pressure/vacuum testing of plastics waste…
-
AS/NZS 2098.1:2006 (R2016)
Methods of test for veneer and plywood – Moisture content of veneer and plywood Published…
-
IEEE 2866.1-2023
IEEE Standard for Device Trusted Extension: Software Architecture (Approved Draft) Published By Publication Date Number…
-
AS 2862.1:2008
Copper, lead, zinc and nickel concentrates – Sampling – Sampling procedures for determination of metal…
-
AS 3818.1:2009
Timber – Heavy structural products – Visually graded – General requirements Published By Publication Date…
-
ISO 28981:2009
Mopeds – Methods for setting the running resistance on a chassis dynamometer Published By Publication…
-
AS 3894.1:2002 (R2013)
Site testing of protective coatings – Non-conductive coatings – Continuity testing – High voltage (‘brush’)…
-
IEEE 2866.1-2023
IEEE Standard for Device Trusted Extension: Software Architecture (Published) Published By Publication Date Number of…
-
AS 2678.1:2008
Zinc sulfide concentrates – Chemical analysis – Determination of zinc – Solvent extraction and EDTA…
-
AS/NZS 2699.1:2000
Built-in components for masonry construction – Wall ties Published By Publication Date Number of Pages…
-
IEEE 488.1 2003
(Replaced)IEEE Standard For Higher Performance Protocol for the Standard Digital Interface for Programmable Instrumentation Published…
-
AS/NZS 2895.1:2007
Performance of household electrical appliances – Microwave ovens – Methods for measuring the performance of…
-
AS 2168.1:2009 (R2019)
Non-destructive testing – Computerized radiography – Systems Published By Publication Date Number of Pages AS…
-
AS 2497.1:2001 (R2013)
Procedures for acceptance testing of refractory products – Batch procedure Published By Publication Date Number…
-
AS 2815.1:2008
Training and certification of occupational divers – Occupational SCUBA diver – Standard Published By Publication…
-
AS 2864.1:2003
Methods for the analysis of rutile – Determination of titanium content – Titrimetric method Published…
-
IEEE 1888.1 2013
IEEE Standard for Ubiquitous Green Community Control Network: Control and Management Published By Publication Date…
-
AS/NZS 2890.1:2004
Parking facilities – Off-street car parking Published By Publication Date Number of Pages AS 2004-03-05…
-
IEEE 2888.1-2023
IEEE Standard for Specification of Sensor Interface for Cyber and Physical Worlds (Published) Published By…
-
IEEE 2888.1-2023
IEEE Standard for Specification of Sensor Interface for Cyber and Physical Worlds (Published) Published By…
-
AS 4828.1:2009
Degradability of plastics – Methods of test – Determination of level of prodegradant ions Published…
-
AS 2888.2:2002 (R2017)
Methods of testing plastics waste fittings – Method for determining dimensions Published By Publication Date…
-
AS 2428.1:2004 (R2016)
Methods of testing smoke/heat release vents – Determination of resistance to leakage during rain Published…
-
AS 2888.1:2002 (R2017)
Methods of testing plastics waste fittings – Method of determining the suitability of connection threads…
-
AS 2806.1:2003 (R2013)
Aluminium ores – Sampling – Sampling procedures Published By Publication Date Number of Pages AS…
-
AS 2293.1:2005
Emergency escape lighting and exit signs for buildings – System design, installation and operation Published…
-
AS 2278.1:2008
Aerosol containers – Metal aerosol dispensers of capacity 50 mL to 1000 mL inclusive Published…