🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASSE 1072 2007

ASSE 1072 2007

$24.38

ASSE Standard #1072-2007 Performance Requirements for Barrier Type Floor Drain Trap Seal Protection Devices

Published By Publication Date Number of Pages
ASSE 2007 24
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Because this barrier method does not automatically & periodically provide water to replenish the trap seal, it must provide a barrier on the inlet side of the trap seal that will minimize evaporation caused by the ambient air on the building side of the trap. This barrier must also provide adequate drainage capabilities required for the floor drain¿s intended use as determined by its design, size & installation location. While developing the requirements & tests for these devices, certain adverse conditions were taken into consideration: introduction of fouling substances such as dirt/sand, floor wax or grease into the device. Drainage requirements are provided to accommodate infrequent & sizeable water flows caused by water line breaks, fixture overflows or backflow preventer discharges.

PDF Catalog

PDF Pages PDF Title
1 Section I
1.0 General
1.1 Application
1.2 Scope
2 T
able 1 – Minimum Flow Rates Through Floor Drains
1.3 Construction
1.4 Reference Documents
3 Section II 3
2.0 Test Specimens
2.1 Samples Submitted
2.2 Samples Tested
Table 2
2.3 Drawings
4 2.4 Rejection
5 Section III
3.0 Performance Requirements and Compliance Testing
3.1 Flow Test
6 Figure 1
7 3.2 Evaporation Test
Figure 2
8 3.3 Trap Seal Interference Test
3.4 Opening Test
3.5 Dirt and Debris Test
9 3.6 Floor Wax Test
3.7 Grease Test
3.8 Life Cycle Test
10 3.9 Physical Test of Membrane Material
Table 3
11 Section IV
4.0 Detailed Requirements
4.1 Materials
4.2 Instructions for Marking and Installation
4.3 Installation Instructions
12 Section V

Related products

ASSE 1072 2007
$24.38