ASTM-A1125/A1125M:2024 Edition

$29.79

A1125/A1125M-24 Standard Specification for Wire Rod for Bridge Cable Wire

Published By	Publication Date	Number of Pages
ASTM	2024	4

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A1125/A1125M-24

Active Standard: Standard Specification for Wire Rod for Bridge Cable Wire

ASTM A1125/A1125M

Scope

1.1 This specification covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to wire rod for bridge cable wire.

1.2 This specification is applied to wire rod with a nominal diameter of 11.0 mm [⁷/₁₆ in.] to 16.0 mm [⁵/₈ in.] intended for use in bridge cable wire.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

bridge cable; bridge cable application; bridge cable wire; steel wire rod; wire rod;

ICS Code

ICS Number Code n/a

DOI: 10.1520/A1125_A1125M-24

Additional information