šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-A711:2012 Edition

ASTM-A711:2012 Edition

$35.75

A711/A711M-07(2012) Standard Specification for Steel Forging Stock

Published By Publication Date Number of Pages
ASTM 2012 4
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

ASTM A711/A711M-07-Reapproved2012

Historical Standard: Standard Specification for Steel Forging Stock

ASTM A711/A711M

Scope

1.1 This specification covers cast carbon and alloy steel ingots and strand castings, semi-wrought ingots and strand castings and rolled or forged blooms, billets, and slabs for forging.

1.2 Blooms, billets, and slabs are semi-finished steel products, hot rolled or forged to approximate cross-sectional dimensions. Blooms and billets may be square, round, octagonal, or rectangular in section; slabs are rectangular. Although no invariable rule prevails between the terms blooms and billets, and they are frequently used interchangeably, the following size distinctions are in general use.

1.2.1 Bloomsā€”Cross-sectional area greater than 36 in.2 [230 cm2].

1.2.2 Billetsā€”Maximum cross-sectional area 36 in.2 [230 cm2].

1.2.3 Slabsā€”Minimum thickness, 1Ā½ in. [4 cm]; width, more than twice the thickness; and generally a cross-sectional area of not less than 16 in.2 [100 cm2].

1.2.4 Ingots either top or bottom poured or secondary remelted are covered.

1.2.5 Strand castings with or without additional reduction are covered.

1.3 Supplementary requirements (S1 to S19) of an optional nature are provided. They shall apply only when specified by the purchaser.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 Unless the order specifies the ā€œMā€ specification, the material shall be furnished to the inch-pound units.

Keywords

billets; blooms; slabs; steel forging stock; Steel ingots; Alloy steel castings–specifications; Alloy steel forgings–specifications; Bars/forging/forging stock–specifications; Carbon steel forgings–specifications; Steel billets and blooms–specifications

ICS Code

ICS Number Code 77.140.85 (Iron and steel forgings)

DOI: 10.1520/A0711_A0711M-07R12

Related products

ASTM-A711
$35.75