ASTM-A727 2000

$35.75

A727/A727M-00 Standard Specification for Carbon Steel Forgings for Piping Components with Inherent Notch Toughness

Published By	Publication Date	Number of Pages
ASTM	2000	4

Guaranteed Safe Checkout

Categories: 77.140.85 - Iron and steel forgings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A727/A727M-00

Historical Standard: Standard Specification for Carbon Steel Forgings for Piping Components with Inherent Notch Toughness

ASTM A727/A727M

Scope

1.1 This specification covers forged carbon steel piping components intended primarily for service in pressure piping systems from -20 to +650^oF [-30 to +345^oC] where inherent notch toughness is desired, but where notch toughness testing is not required. Included are forged or ring-rolled flanges, forged fittings, and valves made to specified dimensions, or to dimensional standards such as the ANSI and API specifications referenced in Section 2.

1.2 This specification is limited to forgings with maximum finished section thicknesses no larger than 2 in. [51 mm].

1.3 It shall be the responsibility of the purchaser to determine whether material meeting the requirements of this specification is satisfactory for the service application.

1.4 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified by the purchaser in the order.

Note 1–There are no provisions for impact testing in this specification. When impact testing is required, refer to Specification A350/A350M.

1.5 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Keywords

carbon equivalent; pipe fittings; steel; piping applications; pressure containing parts; steel flanges; steel forgings; carbon; steel valves; temperature service applications; low

ICS Code

ICS Number Code 77.140.85 (Iron and steel forgings)

DOI: 10.1520/A0727_A0727M-00

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	General Requirements and Ordering Information Materials and Manufacture Heat Treatment Chemical Composition Mechanical Requirements TABLE 1
3	Heat Analysis Product Analysis Hydrostatic Test Rework and Retreatment Repair by Welding Inspection Rejection and Rehearing Certification Product Marking TABLE 2
4	Keywords

Additional information

Standard Title	A727/A727M-00 Standard Specification for Carbon Steel Forgings for Piping Components with Inherent Notch Toughness
Published Code	ASTM
Publication Date	2000
Pages Count	4
ICS Codes	77.140.85 - Iron and steel forgings