🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-B107:2012 Edition

ASTM-B107:2012 Edition

$44.96

B107/B107M-12 Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire

Published By Publication Date Number of Pages
ASTM 2012 19
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This specification covers magnesium-alloy extruded bars, rods, profiles, tubes, and wire of the composition given in Table 1 .

TABLE 1 Chemical Requirements A
Note 1 Analysis shall regularly be made only for the elements specifically mentioned in this table. If, however, the presence of other elements is suspected or indicated in the course of routine analysis to be in amounts greater than the specified limits, further analysis shall be made to determine that the total of these other elements is not in excess of the limits specified in the last column of the table.
Note 2 The following applies to all specified limits in this table: For purposes of acceptance and rejection, an observed value or a calculated value obtained from analysis should be rounded-off to the nearest unit in the last right-hand place of figures used in expressing the specified limit.
A Limits are in weight percent maximum unless shown as a range or otherwise stated.
B These alloy designations were established in accordance with Practice B951 (see also Practice E527 ).
C Includes listed elements for which no specific limit is shown.
D Manganese minimum limit need not be met if iron is 0.005?%, or less.
E Other Rare Earths shall be principally heavy rare earths, for example, Gadolinium, Dysprosium, Erbium, and Ytterbium. Other Rare Earths are derived from the Yttrium, typically 80?% Yttrium 20?% heavy rare earths.
F Zinc + Silver content shall not exceed 0.20?% in WE43B.

1.2 The values stated in either inch-pound or SI units are to be regarded separately as standards. The SI units are shown in brackets or in separate tables or columns. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3 Unless the order specifies the M specification designation, the material shall be furnished to the inch-pound units.

Related products

ASTM-B107
$44.96