Shopping Cart

No products in the cart.

ASTM-B49 2008

$40.63

B49-08a Standard Specification for Copper Rod Drawing Stock for Electrical Purposes

Published By Publication Date Number of Pages
ASTM 2008 7
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

ASTM B49-08a

Historical Standard: Standard Specification for Copper Rod Drawing Stock for Electrical Purposes

ASTM B49

Scope

1.1 This specification covers the requirements for rod drawing stock in diameters from Ā¼ to 13/8 in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to Section 13. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

copper redraw rod; electrical conductors; oxygen-free copper; tough-pitch copper

TABLE 3 Equivalent Resistivity ValuesA

A The equivalent resistivity values for 100 % IACS (soft copper) were each computed from the fundamental IEC value (1/58 Ī© Ā· mm2/m) using conversion factors each accurate to at least seven significant figures.

ICS Code

ICS Number Code 29.050 (Superconductivity and conducting materials)

DOI: 10.1520/B0049-08A

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Ordering Information
Material and Manufacture
2 Chemical Composition
Physical Property Requirements
Mechanical Property Requirements
Other Requirements
TABLE 1
TABLE 2
3 Workmanship, Finish and Appearance
Sampling
Number of Tests and Retests
Test Methods
TABLE 3
FIG. 1
4 Significance of Numerical Limits
Inspection
Rejection and Rehearing
FIG. 2
5 Certification
Test Report
Packaging and Package Marking
Keywords
A1. SAMPLING PLAN
A1.1
A1.2
A1.3
X1. EXPLANATORY INFORMATION
ASTM-B49 2008
$40.63