ASTM-B49 2010

$40.63

B49-10 Standard Specification for Copper Rod Drawing Stock for Electrical Purposes

Published By	Publication Date	Number of Pages
ASTM	2010	7

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM B49-10

Historical Standard: Standard Specification for Copper Rod Drawing Stock for Electrical Purposes

ASTM B49

Scope

1.1 This specification covers the requirements for rod drawing stock in diameters from ¼ to 1³/₈ in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to Section 13. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

cathode; copper redraw rod; electrical conductors; oxygen-free copper; shaving; tough-pitch copper: UNS C11000 (electrolytic tough pitch coper (ETP)); AACSR (aluminum-alloy conductors, steel reinforced); Copper electrical conductors–specifications; Copper rod/bar/shapes–specifications; Redraw rod; UNS C11040; UNS C10100 (oxygen-free copper); UNS C10200 (oxygen-free copper (OF))

ICS Code

ICS Number Code 29.050 (Superconductivity and conducting materials)

DOI: 10.1520/B0049-10

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Ordering Information
2	Material and Manufacture Chemical Composition Physical Property Requirements Mechanical Property Requirements Other Requirements TABLE 1
3	Workmanship, Finish and Appearance Sampling Number of Tests and Retests Test Methods TABLE 2 TABLE 3
4	FIG. 1 FIG. 2
5	Significance of Numerical Limits Inspection Rejection and Rehearing Certification Test Report Packaging and Package Marking Keywords X1. EXPLANATORY INFORMATION