ASTM-B954 2007

$40.63

B954-07 Standard Test Method for Analysis of Magnesium and Magnesium Alloys by Atomic Emission Spectrometry

Published By	Publication Date	Number of Pages
ASTM	2007	9

Guaranteed Safe Checkout

Categories: 77.040.30 - Chemical analysis of metals, 77.120.20 - Magnesium and magnesium alloys, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method describes the analysis of magnesium and its alloys by atomic emission spectrometry. The magnesium specimen to be analyzed may be in the form of a chill cast disk, casting, sheet, plate, extrusion or some other wrought form or shape. The elements covered in the scope of this method are listed in the table below.

Note 1

The concentration ranges given in the above scope are estimates based on two manufacturers observations and data provided by a supplier of atomic emission spectrometers. The range shown for each element does not demonstrate the actual usable analytical range for that element. The usable analytical range may be extended higher or lower based on individual instrument capability, spectral characteristics of the specific element wavelength being used and the availability of appropriate reference materials.

1.2 This test method is suitable primarily for the analysis of chill cast disks as defined in Sampling Practice B 953. Other forms may be analyzed, provided that: (1) they are sufficiently massive to prevent undue heating, (2) they allow machining to provide a clean, flat surface which creates a seal between the specimen and the spark stand, and (3) reference materials of a similar metallurgical condition (spectrochemical response) and chemical composition are available.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety and health statements are given in Section 10.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology Summary of Test Method Significance and Use Interferences Apparatus
3	TABLE 1
4	TABLE 2
5	Reagents and Materials Reference Materials
6	Hazards Sampling, Test Specimens, and Test Units Preparation of Reference Materials and Specimen Preparation of Apparatus
7	Drift Correction
8	Calibration and Standardization Procedure for Analyzing Specimens Calculation or Interpretation of Results Report Precision and Bias Keywords
9	X1. SOURCES OF CRM, RM, AND SPECTROMETER SETTING-UP SAMPLES

Additional information

Standard Title	B954-07 Standard Test Method for Analysis of Magnesium and Magnesium Alloys by Atomic Emission Spectrometry
Published Code	ASTM
Publication Date	2007
Pages Count	9
ICS Codes	77.040.30 - Chemical analysis of metals 77.120.20 - Magnesium and magnesium alloys

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-B954 2007

PDF Catalog

Related products