ASTM-C1450:2010 Edition
$40.63
C1450/C1450M-04(2010) Standard Specification for Non-Asbestos Fiber-Cement Storm Drain Pipe
Published By | Publication Date | Number of Pages |
ASTM | 2010 | 5 |
ASTM C1450/C1450M-04-Reapproved2010
Historical Standard: Standard Specification for Non-Asbestos Fiber-Cement Storm Drain Pipe
ASTM C1450/C1450M
Scope
1.1 This specification covers non-asbestos fiber-cement pipe intended for use in storm-water drainage of highways, airports, farms, foundations, and other similar drainage systems.
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Note 1—Experience has shown that the successful performance of this product depends upon the proper selection of the pipe strength, the type of bedding and backfill, care that the installation conforms to the construction specifications, and provision for adequate inspection at the construction site. This specification does not include requirements for bedding, backfill, the relationship between field load conditions and the strength designation of the pipe, or durability. These requirements should be included in the project specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
drain; drain pipe; fiber-cement; fiber-cement pipe; non-asbestos; storm drain pipe; Fiber-cement products–specifications; Nonasbestos fiber-cement materials–specifications; Storm sewer/drainage pipe–specifications
ICS Code
ICS Number Code n/a
DOI: 10.1520/C1450_C1450M-04R10
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology |
2 | Classification Composition and Manufacture Dimensions, Mass, and Tolerances Sampling TABLE 1 TABLE 2 |
3 | Couplings Fittings Test Methods Inspection Rejection Product Marking and Shipping Keywords |
4 | X1. ADDITIONAL ORDERING INFORMATION X1.1 X2. SAMPLING AND INSPECTION PLANS WITH 6.5 % AOQL X2.1 Inspection by Variables X2.2 Inspection by Attributes |