šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-D1310:2007 Edition

ASTM-D1310:2007 Edition

$40.63

D1310-01(2007) Standard Test Method for Flash Point and Fire Point of Liquids by Tag Open-Cup Apparatus

Published By Publication Date Number of Pages
ASTM 2007 8
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

ASTM D1310-01-Reapproved2007

Historical Standard: Standard Test Method for Flash Point and Fire Point of Liquids by Tag Open-Cup Apparatus

ASTM D1310

Scope

1.1 This test method covers the determination by Tag Open-Cup Apparatus of the flash point and fire point of liquids having flash points between 18 and 165Ā°C (0 and 325Ā°F) and fire points up to 325Ā°F.

1.2 This test method, when applied to paints and resin solutions that tend to skin over or that are very viscous, gives less reproducible results than when applied to solvents. Note 1 – In order to conserve time and sample, the fire point of a material may be determined by the Tag Open-Cup Method by continuing the heating of the specimen to its fire point. Fire points may also be determined by Test Method D 92, which should be used for fire points beyond the scope of this test method.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors pertinent to an assessment of the fire hazard of a particular end use

This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

fire point; flash point; liquids; paints; resin solutions; Tag tester

ICS Code

ICS Number Code 87.060.30 (Solvents)

DOI: 10.1520/D1310-01R07

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Summary of Method
Significance and Use
Apparatus
Materials
Assembly and Preparation of Apparatus
Procedure
3 FIG. 1
4 TABLE 1
5 Instrument Verification
Correction for Barometric Pressure
Report
Precision
Keywords
6 A1. APPARATUS
A1.1
FIG. A1.1
7 A2. SPECIFICATIONS FOR n-HEPTANE, p-XYLENE, ISOPROPANOL, AND DIETHYLENE GLYCOL
A2.1
A2.2
A2.3
A2.4
FIG. A1.2

Related products

ASTM-D1310
$40.63