🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-D2172:2011 Edition

ASTM-D2172:2011 Edition

$44.96

D2172/D2172M-11 Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures

Published By Publication Date Number of Pages
ASTM 2011 13
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: , ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 These test methods cover the quantitative determination of bitumen in hot-mixed paving mixtures and pavement samples. Aggregate extracted from a paving mixture may be used for sieve analysis using Test Method D5444 .

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.2.1 Measurements of volume and mass are only given in SI units because they are the only units typically used in practice when performing this test method.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 7.

Note 1The results obtained by these test methods may be affected by the age of the material tested, with older samples tending to yield slightly lower bitumen content. Best quantitative results are obtained when the test is made on mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt when some aggregates are used and some chlorides may remain within the mineral matter affecting the measured asphalt content.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Summary of Test Methods
Significance and Use
2 Apparatus
Reagents
Hazards
Sampling
Moisture Content
Apparatus
TABLE 1
3 Procedure
FIG. 1
5 Calculation of Bitumen Content
Apparatus
FIG. 2
6 Preparation of Test Portion
Procedure
Calculation of Bitumen Content
Apparatus
Preparation of Test Portions
Procedure
7 FIG. 3
8 FIG. 4
9 Calculation of Bitumen Content
Apparatus
Preparation of Test Portions
Procedure
FIG. 5
10 Calculation of Bitumen Content
Apparatus
FIG. 6
11 Reagents and Materials
Preparation of Test Portions
Procedure
Calculation of Bitumen Content (Applicable to Both Method E-I and Method E-II)
Precision and Bias
12 A1. TEST METHOD A ALTERNATIVE PROCEDURE
A1.1
A1.2
A2. TEST METHOD A (VOLUMETRIC METHOD) ALTERNATIVE PROCEDURE
A2.1
A3. TEST METHOD A MODIFICATION FOR DETERMINATION OF TAR
A3.1
A3.2
A3.3

Related products

ASTM-D2172
$44.96