ASTM-D333 2007

$40.63

D333-01(2007) Standard Guide for Clear and Pigmented Lacquers

Published By	Publication Date	Number of Pages
ASTM	2007	6

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 These test methods cover procedures for testing lacquers and lacquer coatings. The test methods included are listed in Table 1.

Note 1 – In accordance with Terminology D 16, a lacquer is defined as a coating composition that is based on synthetic thermoplastic filmforming material dissolved in organic solvent(s) and that dries primarily by solvent evaporation. Typical lacquers include those based on nitrocellulose, other cellulose derivatives, vinyl resins, acrylic resins, etc.

Note 2 – Lacquers may be applied under such diverse conditions, to so many different surfaces, and their dried films may be subjected to so many kinds of wear and exposure that it is not possible to assure desired performance from a single selection of test methods and numerical results therefrom. Those skilled in lacquer technology may find partial assurance of obtaining desired qualities in various types of lacquers through careful selection of the methods covered herein and intelligent interpretation of results therefrom.

Note 3 – It is intended ultimately to remove all experimental procedures from Test Methods D 333 and to establish them as a guide to the selection of test methods for lacquer and perhaps to interpretation of results therefrom. Temporarily there remain in Test Methods D 333 a few tests that are too short or otherwise presently unsuitable for establishment under separate ASTM designations.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Significance and Use TABLE 1
3	General Requirements Preparation of Sample Weight Per Gallon Nonvolatile Matter Homogeneity Color Viscosity Flash Point Panel Preparation
4	Film Thickness Gloss Color-Pigmented Coatings Color Difference-Pigmented Coatings Elongation Hardness
5	Abrasion Resistance Print Test Household Chemical Resistance Outdoor Exposure Temperature-Change Resistance Salt Fog Water Fog Testing Water Immersion Testing
6	Hiding Power Perspiration Resistance Plasticizer Migration Chip Resistance Light Stability of Clear Coatings Keywords