ASTM-D3381:2012 Edition

$35.75

D3381/D3381M-12 Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

Published By	Publication Date	Number of Pages
ASTM	2012	3

Guaranteed Safe Checkout

Categories: 93.080.20 - Road construction materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3381/D3381M-12

Historical Standard: Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

ASTM D3381/D3381M

Scope

1.1 This specification covers asphalt cements graded by viscosity at 60°C [140°F] for use in pavement construction. Three sets of limits are offered in this specification. The purchaser shall specify the applicable table of limits. In the event the purchaser does not specify limits, Table 1 shall apply. For asphalt cements graded by penetration at 25°C [77°F]. See Specification D946. If needed, volume corrections for asphalt cements should be made according to Practice D4311.

TABLE 1 Requirements for Asphalt Cement, Viscosity Graded at 60°C [140°F]

Note 1—Grading based on original asphalt.

^A If ductility is less than 100, material will be accepted if ductility at 15°C [60°F] is 100 minimum at a pull rate of 5 cm/min.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Keywords

asphalt cement; bitumen; pavement; viscosity

ICS Code

ICS Number Code 93.080.20 (Road construction materials)

DOI: 10.1520/D3381_D3381M-12

Additional information

Penetration, 25°C [77°F], 100 g, 5 s, min	200
Solubility in trichloroethylene, min, %	99.0
Test	Viscosity Grade
Viscosity, 135°C [275°F], min, mm2/s	80
Tests on residue from thin-film oven test:
Viscosity, 60°C [140°F], max, Pa·s	125
Viscosity, 60°C [140°F], Pa·s	25 ± 5
Ductility, 25°C [77°F], 5 cm/min, min, cm	100A
AC-2.5	AC-5
Flash point, Cleveland open cup, min,°C [°F]	165 [325]
ICS Codes	93.080.20 - Road construction materials