ASTM-D3675 2009

$40.63

D3675-09 Standard Test Method for Surface Flammability of Flexible Cellular Materials Using a Radiant Heat Energy Source

Published By	Publication Date	Number of Pages
ASTM	2009	10

Guaranteed Safe Checkout

Categories: 13.220.40 - Ignitability and burning behaviour of materials and products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3675-09

Historical Standard: Standard Test Method for Surface Flammability of Flexible Cellular Materials Using a Radiant Heat Energy Source

ASTM D3675

Scope

1.1 This is a fire test response standard.

1.2 This test method describes the measurement of surface flammability of flexible cellular materials.

1.3 This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not, by itself, incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 Fire testing of products and materials is inherently hazardous, and adequate safeguards for personnel and property shall be employed in conducting these tests. This test method may involve hazardous materials, operations and equipment. Specific information about hazards is given in Section 7.

Note 1—There is no similar or equivalent ISO standard.

1.6 The values stated in SI units are to be regarded as the standard. The values stated in inch-pound units, in parentheses, are for information only and are approximations (see also IEEE/ASTM SI-10).

Keywords

beta factor; I_s; radiant panel; radiant panel index; surface flammability; Building design and construction; Calibration–rubber analysis instrumentation; Cellular rubber; Fire testing–rubber/cellular materials; Fire testing–surface flammability; Flexible cellular materials; Heating tests–rubber; Potentiometric method; Research and development applications; Rubber property analysis; Surface analysis–rubber chemicals/materials

ICS Code

ICS Number Code 13.220.40 (Ignitability and burning behaviour of materials and products)

DOI: 10.1520/D3675-09

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Apparatus
3	FIG. 1
4	Hazards FIG. 2
5	Test Specimens Conditioning Procedure FIG. 3
6	Calculation FIG. 4
7	Report
8	Precision and Bias Keywords A1. PROCEDURE FOR CALIBRATION OF APPARATUS A1.1 Radiation Pyrometer A1.2 Stack Thermocouples
9	A1.3 Calibration Check X1. Commentary REFERENCES

Additional information

Standard Title	D3675-09 Standard Test Method for Surface Flammability of Flexible Cellular Materials Using a Radiant Heat Energy Source
Published Code	ASTM
Publication Date	2009
Pages Count	10
ICS Codes	13.220.40 - Ignitability and burning behaviour of materials and products