ASTM-D4024 2012

$40.63

D4024-12 Standard Specification for Machine Made “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Flanges

Published By	Publication Date	Number of Pages
ASTM	2012	5

Guaranteed Safe Checkout

Categories: 23.040.60 - Flanges, couplings and joints, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D4024-12

Historical Standard: Standard Specification for Machine Made “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Flanges

ASTM D4024

Scope

1.1 This specification covers reinforced-thermosetting resin flanges other than contact-molded flanges. Included are requirements for materials, workmanship, performance, and dimensions.

1.2 Flanges may be produced integrally with a pipe or fitting, may be produced with a socket for adhesive bonding to a pipe or fitting, or may be of the type used in conjunction with either a metallic or nonmetallic backup ring.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only. In cases where materials, products, or equipment are available only in SI units, inch-pound units are omitted.

1.4 The following precautionary caveat pertains only to the test methods portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—Contact molded flanges are covered in Specification D5421 and referenced in Specification D5685.

Note 2—There is no known ISO equivalent to this standard.

Keywords

centrifugally-cast; compression-molded; filament-wound; furan; machine-made; phenolic; polyester; resin-transfer; vinyl ester ; Centrifugally cast plastic pipe–specifications; Compression-molded plastic specimens; Extractable matter content; Fiberglass pipe–specifications; Filament-wound plastic pipe; Flanges/fittings/valves/parts (plastic)(specifications); Furan; Machine-made flanges; Polyester plastics–specifications; Reinforced thermosetting plastics (RTP)–specifications; Reinforced thermosetting-resin pipe (RTRP)–specifications; Resin-transfer flanges; Vinyl ester plastics

ICS Code

ICS Number Code 23.040.60 (Flanges, couplings and joints)

DOI: 10.1520/D4024-12

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Classification
2	Materials and Manufacture Performance Requirements Content Requirements Dimensions TABLE 1
3	Workmanship, Finish, and Appearance Test Methods TABLE 2 TABLE 3
4	TABLE 3 FIG. 1 FIG. 2
5	Product Marking Precision and Bias Keywords

Additional information

Standard Title	D4024-12 Standard Specification for Machine Made “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Flanges
Published Code	ASTM
Publication Date	2012
Pages Count	5
ICS Codes	23.040.60 - Flanges, couplings and joints