ASTM-D412:2015 Edition

$44.96

D412-15a Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension

Published By	Publication Date	Number of Pages
ASTM	2015	14

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D412-15a

Historical Standard: Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension

ASTM D412

Scope

1.1 These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:

Note 1: These two different methods do not produce identical results.

1.2 The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

elongation; set after break; tensile properties; tensile set; tensile strength; tensile stress; yield point;

ICS Code

ICS Number Code 83.060 (Rubber)

DOI: 10.1520/D0412-15A

Additional information

Preview PDF