ASTM-D5930 2009

$40.63

D5930-09 Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique

Published By	Publication Date	Number of Pages
ASTM	2009	5

Guaranteed Safe Checkout

Categories: 83.080.20 - Thermoplastic materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5930-09

Historical Standard: Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique

ASTM D5930

Scope

1.1 This test method covers the determination of the thermal conductivity of plastics over a temperature range from – 40 to 400°C. The thermal conductivity of materials in the range from 0.08 to 2.0 W/m.K can be measured covering thermoplastics, thermosets, and rubbers, filled and reinforced.

1.2 The values stated in SI units shall be regarded as standard.

1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish proper safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this test method.

Keywords

line-source probe; line-source technique; plastics; rubber; thermal conductivity; thermoplastics; thermosets; Line-source probe technique; Thermal analysis (TA)–plastics; Thermal conductance/conductivity; Thermoplastics; Thermosetting plastics

ICS Code

ICS Number Code 83.080.20 (Thermoplastic materials)

DOI: 10.1520/D5930-09

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Summary of Test Method Significance and Use Interferences Apparatus FIG. 1
3	Conditioning Preparation of Test Specimen FIG. 2
4	Calibration Procedure Calculation Report
5	Precision and Bias Keywords REFERENCES TABLE 1

Additional information

Standard Title	D5930-09 Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique
Published Code	ASTM
Publication Date	2009
Pages Count	5
ICS Codes	83.080.20 - Thermoplastic materials