ASTM-D6442 2005

$40.63

D6442-05 Standard Test Method for Determination of Copper Release Rate From Antifouling Coatings in Substitute Ocean Water

Published By	Publication Date	Number of Pages
ASTM	2005	10

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers the laboratory determination of the rate at which copper is released from an antifouling coating in substitute ocean water. The practical limits for quantifying copper release rates by this method are from 1.8 to 500 g cm ^-2 d ^-1 . This range may be extended to 0.2 to 500 g cm ^-2 d ^-1 if the analytical procedure described in is followed.

1.2 The procedure contains the preparation steps for the release rate determination of copper from antifouling paints including apparatus, reagents, holding tank conditions, and sampling point details. Analysis for the concentration of copper in substitute ocean water requires the accurate determination of copper at the low parts g L ^-1 (parts per billion, ppb) level. To detect and correct for reagent impurities, acceptable analytical precision standards are necessary. Therefore, the limit of quantitation (LOQ) for copper in substitute ocean water for the analytical method shall be 10 g L ^-1 (10 ppb) or less. The procedure for determining the LOQ for copper in substitute ocean water for the analytical method is found in .

1.3 A suitable method is described in (graphite furnace atomic absorption spectroscopy, GF-AAS). Other analytical methods may be utilized with relevant procedural changes, as needed, to accommodate selected specific methods. Such methods must meet the limit of quantitation for copper in substitute ocean water of 10 g L ^-1 (10 ppb) or less. See 1.2.

1.4 This test method has not been validated to reflect in situ copper release rates for antifouling products and, therefore should not be used in the process of generating environmental risk assessments. In-service release rates of antifouling (AF) coatings change with natural variability in seawater chemistry, temperature, and hydrodynamic regime.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety practices and to determine the applicability of regulatory limits prior to use. For specific hazard statements, see Section 7.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Summary of Test Method Significance and Use
2	Apparatus Reagents and Materials Hazards
3	Calibration and Standardization Procedure
4	Calculation
5	Report Precision and Bias
6	Keywords A1. DESCRIPTION OF PROPOSED TESTING APPARATUS A1.1 FIG. A1.1
7	A2. DETERMINATION OF THE LOQ FOR COPPER IN SUBSTITUTE OCEAN WATER FOR THE ANALYTICAL METHOD A2.1 Scope A2.2 Procedure A2.3 Calculations TABLE A2.1
8	X1. ANALYSIS FOR COPPER IN SUBSTITUTE OCEAN WATER USING SOLID PHASE EXTRACTION AND GRAPHITE FURNACE ATOMIC ABSORPTION SPECTROSCOPY (GF-AAS) X1.1 Scope X1.2 Apparatus X1.3 Reagents and Materials X1.4 Calibration and Standardization X1.5 Procedure
9	X1.6 Calculation X1.7 Precision and Bias

Additional information

Standard Title	D6442-05 Standard Test Method for Determination of Copper Release Rate From Antifouling Coatings in Substitute Ocean Water
Published Code	ASTM
Publication Date	2005
Pages Count	10

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D6442 2005

PDF Catalog

Related products