ASTM-D6688 2020

1.1 This practice covers the evaluation of the relative resistance of printed matter to liquid chemicals, as evidenced by lack of discoloration, bleeding, or loss of gloss.

1.2 This practice utilizes a sandwich procedure similar in principle to ISO/TC 130 N 589. Spotting or immersion procedures are covered in Test Methods D1308, D1647, and D2248.

1.3 This practice is applicable to prints on any flat substrate including paper, paperboard, metallic foil, metal plate, and plastic films, and produced by any printing process including letterpress, offset lithography, flexography, gravure, silk screen, and non-impact.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.