🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-D7381:2007 Edition

ASTM-D7381:2007 Edition

$40.63

D7381-07 Standard Practice for Establishing Allowable Stresses for Round Timbers for Piles from Tests of Full-Size Material

Published By Publication Date Number of Pages
ASTM 2007 7
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This practice contains procedures for establishing allowable compression parallel to grain and bending stresses for round timbers used for piling, based on results from full-size tests.

Note 1

Allowable stresses for compression perpendicular to grain and shear properties are established in accordance with the provisions of Practice D 2899.

1.2 Stresses established under this practice are applicable to piles conforming to the size, quality, straightness, spiral grain, knot, shake and split provisions of Specification D 25.

1.3 A commentary on the practice is available from ASTM International.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Significance and Use
Sampling Full-Size Round Timbers
Test Methods and Calculation Procedures
3 Reporting Requirements for Sampling and Testing
Analysis of Test Data
Critical Section Located Above the Pile Tip
Effect of Pile Sizes Exceeding Specification
Size Class Minimums
4 Load Sharing Analysis
Establishment of Allowable Stresses
TABLE 1
5 Moisture Content
Treatment
Derivation of Allowable Stresses
Design Considerations
Keywords
TABLE 2
6 X1. DEVELOPING STRESSES FOR ROUND TIMBER PILING BASED ON FULL-SCALE TESTS
X1.1
X1.2
X1.3
X1.4
X1.5
X1.6
X1.7
X1.8
X1.9
X1.10
X1.11
X1.12

Related products

ASTM-D7381
$40.63