ASTM-D7598 2009
$40.63
D7598-09 Standard Test Method for Determination of Thiodiglycol in Water by Single Reaction Monitoring Liquid Chromatography/Tandem Mass Spectrometry
Published By | Publication Date | Number of Pages |
ASTM | 2009 | 8 |
1.1 This procedure covers the determination of thiodiglycol (TDG) in surface water by direct injection using liquid chromatography (LC) and detected with tandem mass spectrometry (MS/MS). TDG is qualitatively and quantitatively determined by this method. This method adheres to single reaction monitoring (SRM) mass spectrometry.
1.2 This test method has been developed in support of the National Homeland Security Research Center, US EPA by Region 5 Chicago Regional Laboratory.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 The Detection Verification Level (DVL) and Reporting Range for TDG are listed in Table 1.
1.4.1 The DVL is required to be at a concentration at least 3 times below the reporting limit (RL) and have a signal/noise ratio greater than 3:1. Fig. 1 displays the signal/noise ratio at the DVL.
1.4.2 The RL is the concentration of the level 1 calibration standard as shown in Table 2. The reporting limit for this method is 100 ? g/L.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology Summary of Test Methods TABLE 1 |
2 | Significance and Use Interferences FIG. 1 TABLE 2 |
3 | Apparatus Reagents and Materials Hazards Sampling Preparation of LC/MS/MS TABLE 3 |
4 | Calibration and Standardization TABLE 4 |
5 | TABLE 5 |
6 | Procedure Calculation or Interpretation of Results TABLE 6 |
7 | Report Precision and Bias Keywords TABLE 7 TABLE 8 |
8 | TABLE 9 TABLE 10 |