🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-E1450:1998 Edition

ASTM-E1450:1998 Edition

$31.25

E1450-92(1998) Standard Test Method for Tension Testing of Structural Alloys in Liquid Helium

Published By Publication Date Number of Pages
ASTM 1998 9
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM E1450-92-Reapproved1998

Historical Standard: Standard Test Method for Tension Testing of Structural Alloys in Liquid Helium

ASTM E1450

Scope

1.1 This test method describes procedures for the tension testing of structural alloys in liquid helium. The format is similar to that of other ASTM tension test standards, but the contents include modifications for cryogenic testing which requires special apparatus, smaller specimens, and concern for serrated yielding, adiabatic heating, and strain-rate effects.

1.2 To conduct a tension test by this standard, the specimen in a cryostat is fully submerged in normal liquid helium (He I) and tested using crosshead displacement control at a nominal strain rate of 10 -3 s -1 or less. Tests using load control or high strain rates are not considered.

1.3 This standard specifies methods for the measurement of yield strength, tensile strength, elongation, and reduction of area. The determination of the elastic modulus is treated in Test Method E111.

Note 1-The boiling point of normal liquid helium (He I) at sea level is 4.2 K (-452.1°F or 7.6°R). It decreases with geographic elevation and is 4.0 K (-452.5°F or 7.2°R) at the National Institute of Standards and Technology in Colorado, 1677 m (5500 ft) above sea level. In this standard the temperature is designated 4 K.

1.4 Values stated in SI units are treated as primary. Values stated in U.S. customary units are treated as secondary.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 5.

Keywords

Adiabatic heating; Cryogenic properties (of materials); Cryostats; Discontinuous yielding; Helium; Liquid helium; Mechanical properties; Structural applications-metals/alloys; Temperature tests-cryogenic; Tension (tensile) properties/tests-metallic materials; tension testing of structural alloys in liquid helium, test

ICS Code

ICS Number Code n/a

DOI: 10.1520/E1450-92R98

Related products

ASTM-E1450
$31.25