ASTM-E215:2004 Edition

$40.63

E215-98(2004)e1 Standard Practice for Standardizing Equipment for Electromagnetic Examination of Seamless Aluminum-Alloy Tube

Published By	Publication Date	Number of Pages
ASTM	2004	7

Guaranteed Safe Checkout

Categories: 77.040.20 - Non-destructive testing of metals, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E215-98-e1-Reapproved2004

Historical Standard: Standard Practice for Standardizing Equipment for Electromagnetic Examination of Seamless Aluminum-Alloy Tube

ASTM E215

Scope

1.1 This practice is intended as a guide for standardizing eddy-current equipment employed in the examination of seamless aluminum-alloy tube. Artificial discontinuities consisting of flat-bottomed or through holes, or both, are employed as the means of standardizing the eddy-current system. General requirements for eddy-current examination procedures are included.

1.2 Procedures for fabrication of reference standards are given in Appendixes and .

1.3 This practice is intended for the examination of tubular products having nominal diameters up to 4 in. [101.6 mm] and wall thicknesses up to the standard depth of penetration (SDP) of eddy currents for the particular alloy (conductivity) being examined and the examination frequency being used. Note 1This practice may also be used for larger diameters or heavier walls up to the effective depth of penetration (EDP) of eddy currents as specified by the using party or parties.

1.4 The values stated in inch-pound units are to be regarded as the standard.

1.5 This practice does not establish acceptance criteria. They must be established by the using party or parties.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aluminum alloy; eddy currents; electromagnetic examination; equipment standardization; NDT; nondestructive testing; tubing

ICS Code

ICS Number Code 77.040.20 (Non-destructive testing of metals)

DOI: 10.1520/E0215-98R04E01

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Significance and Use
2	Basis of Application Apparatus Standardization of Apparatus Procedure
3	Application Keywords X1. PURPOSE, DESCRIPTION, FABRICATION, AND CHECKING OF PRIMARY REFERENCE STANDARDS X1.1 Purpose X1.2 Description
4	X1.3 Identification X1.4 Fabricating Procedure X1.5 Checking FIG. X1.1
5	X1.6 Report TABLE X1.1
6	X2. PURPOSE, DESCRIPTION, FABRICATION, AND CHECKING OF SECONDARY REFERENCE STANDARDS X2.1 Purpose X2.2 Description FIG. X2.1
7	X2.3 Identification X2.4 Fabricating Procedure X2.5 Checking

Additional information

Standard Title	E215-98(2004)e1 Standard Practice for Standardizing Equipment for Electromagnetic Examination of Seamless Aluminum-Alloy Tube
Published Code	ASTM
Publication Date	2004
Pages Count	7
ICS Codes	77.040.20 - Non-destructive testing of metals