ASTM-F3586 2022

$37.38

F3586-22 Standard Practice for Remote ID Means of Compliance to Federal Aviation Administration Regulation 14 CFR Part 89

Published By	Publication Date	Number of Pages
ASTM	2022

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F3586-22

Active Standard: Standard Practice for Remote ID Means of Compliance to Federal Aviation Administration Regulation 14 CFR Part 89

ASTM F3586

Scope

1.1 This practice provides a Means of Compliance (MOC) that gives sufficient clarity to the Unmanned Aircraft System (UAS) or Broadcast Module manufacturers to produce a compliant Remote ID (RID) System (RIDS) such that submitting a Declaration of Compliance2 (DOC) to this MOC will satisfy the requirements of the Federal Aviation Administration (FAA) 14 CFR Part 89 (Part 89) rule.3 This practice also explains what to expect from aircraft operating in compliance to this MOC.

1.2 The FAA provided three options to comply with the Remote ID regulations: Standard Remote ID UAS, Remote ID Broadcast Modules, and FAA-recognized identification areas (FRIAs). The scope of this MOC is to cover both Standard RID and RID Broadcast Modules.

1.3 The FRIA portion of the rule is out of scope since it provides a means to avoid the technical RID requirements by operating within administrative boundaries.

1.4 Both SI and non-SI units are used in this document. Since this is an aviation standard and it addresses FAA rules, some units are used in preference of being consistent with industry and regulatory norms.

1.5 Table of Contents:

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ASTM; broadcast; ; MOC; remote ID;

ICS Code

ICS Number Code n/a

DOI: 10.1520/F3586-22

Additional information

Subset of Options in the F3411 Specification Considered	4
Precision and Bias	9
Scope	1
ANNEX A1—Simulation Option for Accuracy Testing	Annex A1
Test Methods	8
Significance and Use	3
APPENDIX X2—Power Level Rationale	Appendix X2
Requirements and Exceptions from the F3411 Specification	5
Referenced Documents	2
Title	Section
Alternative Applications of Specification F3411 to Meet Part 89 Requirements	6
Keywords	11
APPENDIX X1—External Device for GCS Location Source Rationale	Appendix X1
MOC Requirements Not Covered by the Practice	7
Satisfaction of Rule Requirements	10