ASTM-F577 2009

$40.63

F577-03(2009) Standard Test Method for Particle Size Measurement of Dry Toners

Published By	Publication Date	Number of Pages
ASTM	2009	7

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F577-03-Reapproved2009

Withdrawn Standard: Standard Test Method for Particle Size Measurement of Dry Toners (Withdrawn 2017)

ASTM F577

Scope

1.1 This test method covers aperture particle size analysis using an electronic sensing zone apparatus provided with a digital pulse processor. Dry inks, toners, and so forth, are covered. Particles as small as 1 μm and as large as 120 μm can be analyzed.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

dry toners; particle size; Dry toners; Electronic sensing zone apparatus; Electrostatic copier; Particle analysis–toners

ICS Code

ICS Number Code 19.120 (Particle size analysis. Sieving)

DOI: 10.1520/F0577-03R09

PDF Catalog

PDF Pages	PDF Title
1	Scope Terminology Summary of Test Method Significance and Use Apparatus Reagents and Materials
2	Sampling FIG. 1 FIG. 2
3	FIG. 3 FIG. 4
4	Calibration and Standardization FIG. 5 FIG. 6
5	Procedure for Toner Samples within 1:30 Dynamic Size Range Procedure for Toner Samples with Larger than 1:30 Dynamic Size Range FIG. 7
6	Calculation Interpretation of Results Precision and Bias Keywords
7	REFERENCES TABLE 1