BS EN 1360:2013
$142.49
Rubber and plastic hoses and hose assemblies for measured fuel dispensing systems. Specification
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 32 |
This European Standard specifies minimum requirements and test methods for verification for three types of hoses in two grades and two classes of hose assemblies used for measured fuel dispensing, including oxygenated fuels (up to a maximum of 15 % oxygenated compounds). The assemblies are intended for use at ambient temperatures between –30 °C and +55 °C for normal temperature class and –40 °C and +55 °C for low temperature class at a working pressure ? 16 bar ). As part of the certification of a new dispenser, testing of fuel samples in accordance with EN 228 and EN 590 should be carried out at least eight weeks after the first use of the equipment to avoid unrepresentative sulphur content results.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 7 | 1 Scope 2 Normative references 3 Terms and definitions |
| 8 | 4 Classification 5 Materials and construction 6 Pressure requirements 7 Dimensions and tolerances 7.1 Internal diameters and bend radii |
| 9 | Table 1 — Nominal bore, internal diameter, tolerance and bend radii 7.2 Minimum thickness of lining and cover 7.3 Concentricity 7.4 Tolerance on cut lengths 8 Physical properties 8.1 Compounds |
| 10 | Table 2 — Physical properties of compounds |
| 11 | 8.2 Finished hose Table 3 — Physical properties of hoses |
| 12 | 8.3 Hose assembly Table 4 — Physical properties of hose assembly 9 End fittings |
| 13 | 10 Type tests 11 Frequency of testing 12 Marking 12.1 Hoses 12.2 End fittings |
| 14 | 12.3 Hose assemblies |
| 15 | Annex A (normative) Test method for determination of low temperature resistance at –30 C (for normal temperature class) and –40 C (for low temperature class) A.1 Test piece A.2 Apparatus A.3 Test method |
| 16 | Annex B (normative) Method for the determination of adhesion between components B.1 Dry adhesion B.2 Adhesion after contact with fuel |
| 17 | Annex C (normative) Test method for the determination of low temperature flexibility C.1 Test piece C.2 Apparatus C.3 Test method |
| 19 | Annex D (normative) Test method for the determination of fuel permeation D.1 Test piece D.2 Apparatus D.3 Test method |
| 20 | Annex E (normative) Test method for flammability E.1 Test pieces E.2 Apparatus E.3 Test method |
| 21 | Key Figure E.1 — Arrangement for flammability test |
| 22 | Annex F (normative) End-fitting pull-off test F.1 Test piece F.2 Apparatus F.3 Test method |
| 23 | Annex G (normative) Test method for the determination of leakage (leak test) |
| 24 | Annex H (normative) Test method for fatigue strength under reversed bending stress (flex test) H.1 Apparatus and test pieces Key Figure H.1 — Testing rig H.2 Test method |
| 25 | H.3 Test observations and report |
| 26 | Annex I (normative) Test frequency for type tests and routine tests Table I.1 – Test frequency for type tests and routine tests |
| 28 | Annex J (informative) Test frequency for production acceptance tests Table J.1 – Test frequency for production acceptance tests |
