BS EN 60335-2-89:2010+A2:2017:2018 Edition
$198.66
Household and similar electrical appliances. Safety – Particular requirements for commercial refrigerating appliances with an incorporated or remote refrigerant unit or compressor
Published By | Publication Date | Number of Pages |
BSI | 2018 | 60 |
This clause of Part 1 is replaced by the following.
This standard applies to commercial refrigerators and freezers used for the display of food products, including beverages, for retail sale.
This International Standard specifies safety requirements for electrically operated commercial refrigerating appliances that have an incorporated compressor or that are supplied in two units for assembly as a single appliance in accordance with the manufacturer’s instructions (split system).
Text deleted
NOTE 101 Examples of appliances that are within the scope of this standard are
refrigerated display and storage cabinets;
refrigerated trolley cabinets;
service counters and self-service counters;
blast chillers and blast freezers.
NOTE Z101 Commercial use of these refrigerating appliances is for example their use in restaurants, canteens, hospitals and commercial enterprises such as bakeries, butcheries, supermarkets etc.
As far as is practicable, this standard deals with the common hazards presented by these types of applia ces.
It does not cover those features of construction and operation of refrigerating appliances which are dealt with in ISO standards.
In many countries additional requirements on the safe use of the equipment covered may be specified by the national health authorities, the national authorities responsible for the protection of labour, the national water supply authorities and similar authorities.
NOTE 102 Attention is drawn to the fact that
for appliances intended to be used in vehicles or on board ships or aircraft, additional requirements may be necessary;
Text deleted
- —
for scrapping of appliances, additional requirements may be necessary.
NOTE 103 This standard does not apply to
domestic refrigerating appliances (IEC 60335‑2‑24)
industrial refrigerating systems;
motor-compressors (IEC 60335‑2‑34);
commercial dispensing appliances and vending machines (IEC 60335‑2‑75);
commercial ice-cream appliances;
commercial ice makers;
cold temperature rooms;
multiple refrigerated chambers with a remote compressor.
appliances with a charge greater than 150 g of flammable refrigerant in each separate refrigerant circuit.
Text deleted
Products covered by this standard do not create a noise hazard; therefore no specific provisions concerning noise are given.
PDF Catalog
PDF Pages | PDF Title |
---|---|
2 | National foreword |
4 | European Foreword |
6 | Foreword to amendment A1 Foreword to amendment A1 |
7 | Foreword to amendment A2 Foreword to amendment A2 |
8 | Annex ZC (normative) Normative references to international publications with their corresponding European publications |
10 | Annex ZE (informative) Specific additional requirements for appliances and machines intended for commercial use |
11 | Annex ZF (informative) Criteria applied for the allocation of products covered by standards in the EN 60335 series, under LVD or MD |
12 | Annex ZZ (informative) Coverage of Essential Requirements of Directive 2006/42/EU |
15 | FOREWORD |
17 | INTRODUCTION |
19 | 1 Scope |
20 | 2 Normative references |
21 | 3 Terms and definitions |
22 | 4 General requirement |
23 | 5 General conditions for the tests 5.2 Addition: 5.3 Addition: 5.7 Addition: |
24 | 5.10 Addition: 6 Classification 7 Marking and instructions |
25 | 7.1 Modification: |
26 | 7.6 Addition: 7.12 Modification: |
27 | 7.12.1 Addition: |
28 | 7.12.Z101 Information shall be given: |
29 | 7.14 Addition: 7.15 Addition: 8 Protection against access to live parts 9 Starting of motor-operated appliances 10 Power input and current 10.2 Modification: |
30 | 11 Heating 11.1 Replacement 11.2 Replacement 11.7 Replacement 11.8 Modification |
32 | 12 Void 13 Leakage current and electric strength at operating temperature 14 Transient overvoltages 15 Moisture resistance 15.2 Addition |
33 | 16 Leakage current and electric strength 17 Overload protection of transformers and associated circuits 18 Endurance 19 Abnormal operation 19.1 Addition 19.8 Addition: 19.9 Not applicable |
35 | 20 Stability and mechanical hazards 21 Mechanical strength |
36 | 22 Construction 22.6 Addition 22.7 Replacement |
37 | 22.33 Addition: |
46 | 23 Internal wiring 23.3 Modification: 24 Components 24.1 Addition: |
47 | 24.1.3 Addition: 24.1.4 Addition: |
48 | 24.5 Addition: 24.7 Modification: 25 Supply connection and external flexible cords 25.2 Modification: 26 Terminals for external conductors 27 Provision for earthing |
49 | 28 Screws and connections 29 Clearances, creepage distances and solid insulation 29.2 Addition: 30 Resistance to heat and fire 30.1 Addition: 30.2 Addition: 30.2.2 Not applicable. |
50 | 31 Resistance to rusting 32 Radiation, toxicity and similar hazards |
52 | Annex C (normative) Ageing test on motors |
53 | Annex D (normative) Thermal motor protectors |
54 | Annex P (informative) Guidance for the application of this standard to appliances used in warm damp equable climates |
55 | Annex AA (normative) Locked-rotor test of fan motors |
57 | Annex BB (normative) Non-sparking “n” electrical apparatus |
58 | Bibliography |