BS EN 61169-40:2011
$142.49
Radio-frequency connectors – Sectional specification for 2.4 series RF connectors
| Published By | Publication Date | Number of Pages |
| BSI | 2011 | 28 |
This part of IEC 61169 provides information and rules for preparation of detail specification of 2.4 series R.F connectors together with the pro-forma blank detail specification.
The 2.4 series thread mated connectors with characteristic impedance 50 Ω are used for millimeter wave applications, connecting with RF cables or microstrips. The operating frequency limit is up to 50 GHz.
These connectors can be intermated with 1,85 mm (IEC 61169-32 and IEEE 287-2007) connectors.
It also prescribes mating face dimensions for high performance connectors grade 1, dimensional detail of standard test connectors grade 0, gauging information and tests selected from IEC 61169-1 applicable to all detail specifications relating to 2.4 series RF connectors.
This specification indicates recommended performance characteristics to be considered when writing a detail specification and it covers test schedules and inspection requirements for assessment levels M and H.
NOTE Metric dimension are original dimensions.
All undimensioned pictorial configurations are for reference purpose only.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Mating face and gauge information 3.1 Dimensions – High performance connectors – Grade 1 Figures Figure 1 – Connector with pin-centre contact Tables Table 1 – Dimensions of connector with pin-centre contact |
| 10 | Figure 2 – Connector with socket-centre contact Table 2 – Dimensions of connector with socket-centre contact |
| 11 | 3.2 Gauges Figure 3 – Gauge pins for socket-centre contact Table 3 – Dimensions of gauge pins for socket-centre contact |
| 12 | 3.3 Dimensions – Standard test connectors – Grade 0 Figure 4 – Connector with pin-centre contact Table 4 – Dimensions of connector with pin-centre contact |
| 13 | Figure 5 – Connector with socket-centre contact Table 5 – Dimensions of connector with socket-centre contact |
| 14 | 4 Quality assessment procedure 4.1 General 4.2 Rating and characteristics (see Clause 6 of IEC 61169-1) Table 6 – Preferred climatic categories (see IEC 60068-1) |
| 15 | Table 7 – Rating and characteristics |
| 17 | 4.3 Test schedule and inspection requirements Table 8 – Acceptance tests Table 9 – Periodic tests |
| 19 | 4.4 Procedures 5 Instructions for preparation of detail specifications 5.1 General 5.2 Identification of the detail specification 5.3 Identification of the component |
| 20 | 5.4 Performance 5.5 Marking, ordering information and related matters 5.6 Selection of tests, test conditions and severities |
| 21 | 6 Blank detail specification pro-forma for 2.4 connectors |
| 26 | Bibliography |
