BS EN 61169-51:2015
$167.15
Radio-frequency connectors – Sectional specification for RF coaxial connectors with inner diameter of outer conductors 13,5 mm with bayonet lock. Characteristic impedance 50 O (type QLI)
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 34 |
IEC 61169-51:2015 provides information and rules for the preparation of detail specifications (DS) for type QLI R.F. coaxial connectors with quick lock. The connectors are normally used with 50 Ohms corrugated cable and flexible cables for middle power applications in an operating range up to 6 GHz. It describes the interface dimensions for general purpose connectors with gauging information and the mandatory tests selected from IEC 61169-1 applicable to all detail specifications relative to type QLI connectors. This specification indicates the recommended performance characteristics to be considered when writing a DS and covers all tests schedules and inspection requirements.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 8 | FOREWORD |
| 10 | INTRODUCTION |
| 11 | 1 Scope 2 Normative references |
| 12 | 3 Mating face and gauge information 3.1 Dimensions – General connectors 3.1.1 Connector with socket-centre contact Figures Figure 1 – Connector with socket-centre contact with 2 options(for dimensions and key, see Table 1) |
| 13 | Figure 2 – Detail of bayonet lock groove, option 1 (for dimensions and key, see Table 1) Figure 3 – Detail of bayonet lock groove, option 2 (for dimensions and key, see Table 1) |
| 14 | Figure 4 – Female centre contact (for dimensions and key, see Table 1 |
| 15 | Tables Table 1 – Dimensions of connector with socket-centre contact |
| 16 | 3.1.2 Connector with pin-centre contact Figure 5 – Connector with pin-centre contact (for dimensions and key, see Table 2) Figure 6 – Details of pin-centre contact (for dimensions, see Table 2) |
| 17 | Table 2 – Dimensions of connector with pin-centre contact |
| 18 | 3.2 Gauges for connector with socket-centre contact 3.2.1 Centre contact 3.2.2 Test procedure Figure 7– Gauge pin for socket-centre contact (for dimensions, see Table 3) Table 3 – Gauge dimensions for socket-centre contact |
| 19 | 3.2.3 Gauge for outer contact 4 Quality assessment procedures 4.1 General 4.2 Ratings and characteristics Figure 8 – Gauge ring for socket outer contact (for dimensions, see Table 4) Table 4 – Dimensions of gauge ring for socket outer contact |
| 20 | Table 5 – Rating and characteristics |
| 22 | 4.3 Periodic tests Table 6 – Acceptance tests |
| 23 | Table 7 – Periodic tests |
| 24 | 4.4 Procedures for the qualification approval 4.4.1 Quality conformance inspection 4.4.2 Qualification approval and its maintenance 5 Instructions for preparation of detail specifications (DS) 5.1 General 5.2 Identification of the component |
| 25 | 5.3 Performances 5.4 Marking, ordering information and related matters 5.5 Selection of tests, test conditions and severities |
| 26 | 5.6 Blank detail specification pro-forma for type QLI connector |
| 31 | 6 Marking 6.1 Marking of component 6.2 Marking and contents of package |
