BS EN ISO 15630-2:2019
$167.15
Steel for the reinforcement and prestressing of concrete. Test methods – Welded fabric and lattice girders
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 34 |
This document specifies chemical and mechanical test methods and measurement methods of geometrical characteristics applicable to welded fabric and lattice girders for the reinforcement of concrete.
NOTE In some countries, the expression “welded wire reinforcement” is used in place of “welded (wire) fabric”.
For those tests not specified in this document (e.g. bend test, rib/indentation geometry, mass per metre), ISO 15630‑1 is applicable.
This document does not cover the sampling conditions that are dealt with in the product standards.
A list of options for agreement between the parties involved is provided in Annex A.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 4 | European foreword |
| 7 | Foreword |
| 8 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms, definitions and symbols |
| 10 | 4 General provisions concerning test pieces |
| 11 | 5 Tensile test 5.1 Test piece 5.2 Test equipment 5.3 Test procedure |
| 13 | 6 Bend test on welded intersection of welded fabric 6.1 Test piece 6.2 Test equipment 6.3 Test procedure |
| 14 | 6.4 Interpretation of test results 7 Shear test 7.1 Determination of the weld shear force of welded fabric (Fs) 7.1.1 Test piece 7.1.2 Test equipment |
| 18 | 7.1.3 Test procedure |
| 19 | 7.2 Lattice girders 7.2.1 Shear test on weld points |
| 20 | 7.2.2 Shear test on clamped joints |
| 23 | 7.2.3 Test apparatus 7.2.4 Test piece 7.2.5 Test procedure |
| 24 | 8 Axial force fatigue test of welded fabric 8.1 Principle of test 8.2 Test piece 8.3 Test equipment |
| 25 | 8.4 Test procedure 8.4.1 Provisions concerning the test piece 8.4.2 Upper force (Fup) and force range (Fr) 8.4.3 Stability of force and frequency 8.4.4 Counting of force cycles 8.4.5 Frequency 8.4.6 Temperature 8.4.7 Validity of the test 9 Chemical analysis |
| 26 | 10 Measurement of the geometrical characteristics 10.1 Welded fabric 10.1.1 Test piece 10.1.2 Test equipment 10.1.3 Test procedure 10.2 Lattice girders 10.2.1 Test piece 10.2.2 Test equipment 10.2.3 Measuring procedure 11 Specialized tests 11.1 Tensile test at elevated temperature 11.1.1 General 11.1.2 Test piece |
| 27 | 11.1.3 Test equipment 11.1.4 Test procedure 11.2 Tensile test at low temperature 11.2.1 General 11.2.2 Test piece 11.2.3 Test equipment 11.2.4 Test procedure 11.3 Cyclic inelastic load test 11.3.1 Principle of the test |
| 28 | 11.3.2 Test piece 11.3.3 Test equipment 11.3.4 Test procedure |
| 29 | 12 Test report |
| 30 | Annex A (informative) Options for agreement between the parties involved |
| 31 | Bibliography |
