BS EN ISO 16228:2018
$167.15
Fasteners. Types of inspection documents
| Published By | Publication Date | Number of Pages |
| BSI | 2018 | 36 |
This document specifies the different types of fastener inspection documents issued by the fastener manufacturer or distributor and/or by the external authorized representative on specific request of the purchaser at the time of the order.
-
declaration of compliance (F2.1);
-
test reports (F2.2, F3.1 and F3.2).
NOTE The term “certificate” is in common use, however for fastener inspection documents the terminology to be used is “test report”.
This document specifies requirements for the content of each fastener inspection document, in conjunction with the order, the relevant standards and/or specified requirements.
This document is applicable to finished fasteners such as bolts, screws, studs, nuts, washers, pins, rivets, etc. made of steel, stainless steel, non-ferrous metal or non-metallic material.
This document does not apply to special-purpose or specially engineered applications requiring other types of procedures (e.g. initial samples).
Examples of inspection documents are given in Annex A. An example of a coding system identifying the sections in fastener inspection documents is given in Annex B.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 4 | European foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references |
| 10 | 3 Terms and definitions 4 Inspection 4.1 Types of inspection documents for material |
| 11 | 4.2 Types of inspection for fasteners 4.2.1 Non-specific inspection for fasteners 4.2.2 Specific inspection for fasteners 4.3 Types of inspection documents for fasteners 4.3.1 General 4.3.2 Fastener declaration of compliance F2.1 |
| 12 | 4.3.3 Fastener test report F2.2 4.3.4 Fastener test report F3.1 4.3.5 Fastener test report F3.2 5 Requirements for fastener inspection documents 5.1 General |
| 13 | 5.2 Maintenance of data for inspection documents 5.3 Traceability 5.4 Inspection document sources |
| 14 | 5.5 Subcontracted tests and/or inspection 5.6 Sampling 5.7 Reporting of test/inspection results |
| 15 | 5.8 Minimum results to be included for each type of fasteners |
| 17 | 5.9 Validation of the inspection document 6 Required content for each type of fastener inspection document 6.1 General 6.2 Content of the fastener declaration of compliance F2.1 |
| 18 | 6.3 Content of the fastener test report F2.2 |
| 19 | 6.4 Content of the fastener test report F3.1 |
| 20 | 6.5 Content of the fastener test report F3.2 |
| 21 | 7 Amendment to inspection documents 8 Transmission of inspection documents |
| 22 | Annex A (informative) Examples of inspection documents |
| 26 | Annex B (informative) Code numbers applicable to fasteners |
| 34 | Bibliography |
