BS ISO 19206-1:2018
$142.49
Road vehicles. Test devices for target vehicles, vulnerable road users and other objects, for assessment of active safety functions – Requirements for passenger vehicle rear-end targets
| Published By | Publication Date | Number of Pages |
| BSI | 2018 | 30 |
This document specifies performance requirements for surrogate targets used to assess the system detection and activation performance of active safety systems.
This document specifies the properties of a vehicle target that will allow it to represent a passenger vehicle in terms of size, shape, reflection properties, etc. for testing purposes. The document addresses the detection requirements for a vehicle target in terms of sensing technologies commonly in use at the time of publication of this document, and where possible, anticipated future sensing technologies. It also addresses methodologies to verify the target response properties to these sensors, as well as performance requirements for the target carrier.
This document specifies the properties of the vehicle target for simulation of rear-end scenarios, with overlap greater than 50 %. The specifications of vehicle targets in this document are intended to address current and anticipated test protocols related to safety critical events in which the subject vehicle approaches a stopped, braking or slower moving (target) vehicle from behind and in the forward path of the subject vehicle.
This document does not address the test procedures in terms of speeds, positions, or timing of events. Performance criteria for the active safety system are also not addressed.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 7 | Foreword |
| 8 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | 4 Symbols and abbreviated terms 5 Vehicle target specifications 5.1 Vehicle classes and target applicability |
| 11 | 5.2 Reference dimensional measurements |
| 12 | 5.3 Safety considerations 5.4 Repairability 5.5 Environmental conditions 6 Vehicle target response to sensing technologies 6.1 General 6.2 Optical requirements 6.2.1 General 6.2.2 Reference measurements |
| 13 | 6.2.3 Stability of dimensions for optical recognition 6.2.4 Viewing angles 6.2.5 Features related to optical requirements 6.3 Radar requirements 6.3.1 Reference measurements of radar properties 6.3.2 Reference measurements 6.3.3 Radar cross section, static measurements and requirements 6.3.4 Radar recognition features of vehicle target 6.3.5 Stability of dimensions for radar recognition |
| 14 | 6.4 Thermal requirements for Far Infrared vision systems 6.4.1 General 6.4.2 Reference measurements 6.4.3 Thermal characteristics 6.5 Calibration 7 Motion and positioning during test for VT including target carrier system 7.1 General requirements |
| 15 | 7.2 Longitudinal positioning 7.2.1 Speed range for operation 7.2.2 Accelerations 7.3 Lateral positioning 7.3.1 General 7.3.2 Yaw angle 7.3.3 Lateral position 7.4 Vertical positioning 7.4.1 General 7.4.2 Pitch angle 7.4.3 Vertical motions |
| 16 | Annex A (informative) Vehicle classes |
| 18 | Annex B (normative) Sensor-specific recognition properties |
| 21 | Annex C (normative) Vehicle target measurements and measurement equipment |
| 24 | Annex D (informative) Field verification of vehicle target properties |
| 25 | Annex E (informative) Examples of existing vehicle rear-end targets |
| 28 | Bibliography |
