BS ISO 2330:2002
$86.31
Fork-lift trucks. Fork arms. Technical characteristics and testing
| Published By | Publication Date | Number of Pages |
| BSI | 2002 | 12 |
This International Standard specifies manufacturing, testing and marking requirements for solid-section fork arms, for quantity production and with all types of mounting. These include, but are not limited to, hook, shaft or pin, bolt-on and roller type fork arms.
By agreement between the fork arm manufacturer and the purchaser, these requirements may also be applied to fork arms not intended for quantity manufacture.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 3 | TitlePage – Fork-lift trucks�— Fork arms�— Technical characteristics and testing |
| 5 | Foreword – Foreword |
| 7 | Scope – 1��� Scope NormativeReference – 2��� Normative references Clause1 – 4��� Manufacture Clause1 – 5��� Testing UntitledSubclause2 – 5.1��� A prototype fork arm shall be subjected to, and meet the requirements… |
| 8 | UntitledSubclause2 – 5.2��� The tests in Clause1 – 6��� Yield test Subclause2 – 6.1��� Test load Subclause3 – 6.1.1��� Fork arms each of specified capacity up to and including Subclause3 – 6.1.2��� Fork arms each of specified capacity greater than Subclause2 – 6.2��� Procedure |
| 9 | Subclause2 – 6.3��� Requirement Clause1 – 7��� Impact test Subclause2 – 7.1��� Sampling Subclause2 – 7.2��� Procedure Subclause2 – 7.3��� Requirement Clause1 – 8��� Fatigue test Subclause2 – 8.1��� Test load magnitude, frequency and duration UntitledSubclause3 – 8.1.1��� The dynamic test load shall be of constant amplitude and have a pea… UntitledSubclause3 – 8.1.2��� The test load frequency shall be UntitledSubclause3 – 8.1.3��� The duration of the test shall be not less than 10 Subclause2 – 8.2��� Procedure Subclause2 – 8.3��� Requirement |
| 10 | Clause1 – 9��� Surface-crack detection Clause1 – 10��� Marking UntitledSubclause2 – 10.1��� At the position indicated in UntitledSubclause2 – 10.2��� The truck manufacturer’s identification and part number may be shown… |
