BS ISO 3547-5:2020
$142.49
Plain bearings. Wrapped bushes – Checking the outside diameter
| Published By | Publication Date | Number of Pages |
| BSI | 2020 | 24 |
This document specifies, following ISO 12301, the checking of the outside diameter of wrapped bushes ( ISO 3547-2:2017, methods A, B and D) and describes the necessary checking methods and measuring equipment.
NOTE
The dimensions and tolerances of wrapped bushes are given in ISO 3547-1 . Checking the wall thickness is the subject of ISO 3547-7 .
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions 4 Symbols and units |
| 10 | 5 Outside diameter, Do 6 Purpose of checking 7 Methods of checking 7.1 General |
| 11 | 7.2 Checking method A — Measurement of outside diameter, Do 7.3 Checking method B — Gauging of outside diameter, Do 7.4 Checking method D — Measurement of outside diameter, Do > 120 mm 8 Selection of checking method for outside diameter 9 ISO 3547-2:2017, test A — Outside diameter, Do 9.1 Measuring equipment |
| 13 | 9.2 Requirements for checking the block and the setting plug |
| 18 | 9.3 Determination of correction factor, C 9.4 Procedure |
| 19 | 9.5 Measuring errors 9.5.1 General 9.5.2 Errors due to measuring equipment 9.5.3 Errors due to the bush 9.5.4 Errors due to human factors 9.6 Summary of the factors relating to the measurement of the outside diameter, Do, of the bush 9.6.1 Checking load, Fch 9.6.2 Diameter of the checking block, dch,1, and of the setting plug, dch,2 9.6.3 Upper limiting value and lower limiting value for ∆z |
| 20 | 9.6.4 Correction factor, C 9.6.5 Conversion of the indicated measured value, ∆z, for outside diameter 10 ISO 3547-2:2017, test B — Outside diameter, Do 10.1 Gauging equipment 10.2 Requirements for measuring equipment |
| 21 | 10.3 Procedure 10.4 Measuring errors 11 ISO 3547-2, test D — Outside diameter, Do > 120 mm 11.1 Gauging equipment 11.2 Measuring equipment |
| 22 | 11.3 Procedure 11.4 Measuring errors 12 Specifications on drawings of bushes 13 Specifications for control of the checking equipment 13.1 Gauging equipment 13.2 Measuring equipment |
| 23 | Bibliography |
