BSI 17/30351968 DC:2017 Edition
$13.70
BS EN 13813. Screed material and floor screeds. Screed material. Properties and requirements
| Published By | Publication Date | Number of Pages |
| BSI | 2017 | 44 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Terms and definitions |
| 10 | 4 Designation of screed materials and characteristics 5 Product characteristics 5.1 General |
| 13 | 5.2 Characteristics related to mechanical resistance |
| 16 | 5.3 Reaction to fire 5.3.1 General |
| 17 | 5.3.2 Screed materials classified as Class A1 without the need for testing (CWT) 5.3.3 Screed materials classified as class E without the need for further testing (CWFT) |
| 18 | 5.3.4 Screed materials classified according to the test results 5.4 Release of corrosive substances 5.5 Compressive strength 5.6 Flexural strength |
| 19 | 5.7 Wear resistance 5.8 Surface hardness |
| 20 | 5.9 Resistance to indentation 5.10 pH value 5.11 Impact resistance 5.12 Bond strength |
| 21 | 5.13 Shrinkage 5.14 Modulus of elasticity in compression 5.15 Vertical water permeability 5.16 Freeze–thaw resistance 5.17 Density |
| 22 | 5.18 Compressive stress at 10 % strain 5.19 Special characteristics 5.19.1 Consistency 5.19.2 Setting time 5.19.3 Resistance to rolling wheel with floor covering 5.19.4 Chemical resistance 5.19.5 Water vapour permeability 5.19.6 Electrical resistance 5.19.7 Thermal resistance |
| 23 | 6 Assessment and verification of constancy of performance – AVCP 6.1 General 6.2 Type testing 6.2.1 General 6.2.2 Test samples, testing and compliance criteria |
| 24 | 6.2.3 Test reports 6.2.4 Shared other party results |
| 25 | 6.3 Factory production control (FPC) 6.3.1 General |
| 26 | 6.3.2 Requirements 6.3.2.1 General |
| 27 | 6.3.2.2 Equipment 6.3.2.3 Raw materials and components 6.3.2.4 Traceability and marking 6.3.2.5 Controls during manufacturing process 6.3.2.6 Product testing and evaluation |
| 28 | 6.3.2.7 Non-complying products |
| 29 | 6.3.2.8 Corrective action 6.3.2.9 Handling, storage and packaging 6.3.3 Product specific requirements |
| 30 | 6.3.4 Initial inspection of factory and of FPC 6.3.5 Continuous surveillance of FPC 6.3.6 Procedure for modifications |
| 31 | 6.3.7 One-off products, pre-production products (e.g. prototypes) and products produced in very low quantity 7 Marking and labelling |
| 33 | Annex ZA (informative)Relationship between this European Standard with Regulation (EU) No 305/2011 |
