BSI PD IEC TS 62351-100-3:2020

$142.49

Power systems management and associated information exchange. Data and communications security – Conformance test cases for the IEC 62351-3, the secure communication extension for profiles including TCP/IP

Published By	Publication Date	Number of Pages
BSI	2020	32

Guaranteed Safe Checkout

Category: BSI

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This part of IEC 62351, which is a technical specification, describes test cases of data and communication security for telecontrol equipment, Substation Automation Systems [SAS] and telecontrol systems, including front-end functions of SCADA.

The goal of this document is to enable interoperability by providing a standard method of testing protocol implementations to verify that a device fulfils the requirement of IEC 62351-3. Note that conformity to IEC 62351-3 does not guarantee interoperability between devices using different implementations. It is expected that using this specification during testing will minimize the risk of non-interoperability. A basic condition for this interoperability is a passed conformance test of both devices.

The scope of this document is the specification of common available procedures and definitions for conformance and/or interoperability testing to ensure conformity to IEC 62351-3. The conformance test cases defined here are focused to verify the conformant integration of the underlying authentication/encryption protocol (TLS), as specified in IEC 62351-3, to protect TCP/IP based communications.

This document is not intended to test the underlying authentication/encryption protocol required by IEC 62351-3 to be implemented over TCP/IP (TLS). The conformance testing of the authentication/encryption protocol over TCP/IP is outside the scope of this document.

This document deals with data and communication security conformance testing; therefore, other requirements, such as safety or EMC are not covered. These requirements are covered by other standards (if applicable) and the proof of compliance for these topics is done according to these standards.

PDF Catalog

PDF Pages	PDF Title
2	undefined
4	CONTENTS
5	FOREWORD
7	INTRODUCTION
8	1 Scope 2 Normative references
9	3 Terms, definitions and abbreviated terms 3.1 Terms and definitions
10	3.2 Abbreviated terms 4 General 4.1 Normatives covered by this document
11	4.2 Conformance testing structure 4.2.1 General 4.2.2 Conformance testing addressed per station type 4.2.3 Normal procedure tests and resiliency tests
12	4.3 Conformance testing requirements 4.3.1 Testing within the context of an application 4.3.2 Requirements for the device under test 4.3.3 Requirements for the test facility
13	4.3.4 Test logging
14	5 Verification of Configuration parameters 5.1 General 5.2 Configuration parameters Tables Table 1 – Configuration Parameters
16	6 Verification of IEC 62351-3 requirements 6.1 General 6.2 Normal procedure test cases Table 2 – IEC 62351-3 requirements: Normal procedure tests
19	6.3 Resiliency test cases Table 3 – IEC 62351-3 requirements: Resiliency tests
24	7 Tests Results Chart 7.1 Verification of Configuration Parameters Table 4 – Test results chart: Verification of configuration parameters
25	7.2 Verification of IEC 62351-3 requirements Table 5 – Test results chart: Verification of IEC 62351-3 requirements