EIA 60938-2-2-2014

INTRODUCTION

Blank detail specification

This blank detail specification forms the basis for a uniform
procedure for a common mark. It implements the approval schedule
for safety tests only in IEC 60938-2, requires a declaration of
design for parameters relevant to safety tests and prescribes
conformance tests to be conducted on every lot prior to its release
and re-qualification tests depending on changes of the design.

In comparison with IEC 60938-2-1 which provides safety tests and
performance tests, this specification is restricted to safety tests
only.

The use of IEC 60938-2-1 may be more appropriate for components
manufactured in mass production, whereas this specification may be
necessary in those cases where approval and re-qualification tests
contribute considerably to the costs of the product.

A blank detail specification is a supplementary document to the
sectional specification and contains requirements for style and
layout and minimum content of detail specifications. In the
preparation of detail specifications the content of 1.4 of the
sectional specification shall be taken into account.

The numbers between square brackets on the first page of the
detail specification correspond to the following information which
shall be inserted in the position indicated.