IEEE 1816-2013
$46.04
IEEE Guide for Preparation Techniques of Extruded Dielectric, Shielded Cables Rated 2.5 kV through 46 kV and the Installation of Mating Accessories
| Published By | Publication Date | Number of Pages |
| IEEE | 2013 | 35 |
New IEEE Standard – Active. Accepted best industry practices for the preparation of extruded dielectric shielded medium voltage cables rated 2.5 kV through 46 kV for the installation of mating accessories are defined in this guide. The information is intended to supplement cable accessory manufacturer installation instructions. The guide aims to provide a single source covering the proper methods to prepare cables for termination and jointing to maximize long-term, reliable operation of electrical power cable systems.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | IEEE Std 1816-2013 Front Cover |
| 3 | Title page |
| 6 | Notice to users Laws and regulations Copyrights Updating of IEEE documents Errata Patents |
| 8 | Participants |
| 10 | Introduction |
| 11 | Contents |
| 13 | Important Notice 1. Overview 1.1 Scope 1.2 Purpose |
| 14 | 2. Normative references 3. Definitions |
| 15 | 4. Cable construction 4.2 Conductor |
| 16 | 4.3 Conductor shield 4.4 Insulation 4.5 Insulation shield 4.6 Electrical stress control |
| 19 | 4.7 Metallic shield 4.8 Metallic shield water block 4.9 Outer jacket 5. Cable preparation 5.1 Cable accessory selection and tool requirements |
| 20 | 5.2 Cable training and termination 5.3 Final cable cut 5.4 Jacket removal |
| 21 | 5.5 Exposing metallic shield 5.6 Non-metallic insulation shield removal |
| 22 | 5.7 Insulation |
| 23 | 5.8 Conductor shield removal 5.9 Insulation chamfering 5.10 Cleaning the insulation 5.11 Strands and miscellaneous |
| 24 | 6. Conductor connector installation 6.1 Connector types 6.2 Conductor preparation |
| 25 | 6.3 Preparing for Installation 6.4 Connector markings |
| 26 | 6.5 Crimping the connector |
| 28 | 6.6 Bolted connectors 6.7 Excess inhibitor 6.8 Flash |
| 29 | 7. Cable accessory installation |
| 30 | 8. Metallic shield connection |
| 31 | 9. Cable seal and jacket restoration 9.1 Cable end seal 9.2 Joint jacket restoration 10. Cable shield ground connection |
| 32 | Annex A (informative) Bibliography |
| 33 | Annex B (informative) Compression tools B.1 Scissor-type tools B.2 Tool using two opposing dies B.3 Tools using four-head indents B.4 Tools using single indents B.5 Tool adjustment and calibration |
| 34 | Annex C (informative) Recommended minimum cable bending radii |
| 35 | Annex D (informative) Suggested cleaning procedure for corroded conductors |
Related products
-
IEEE 1896 2016
IEEE Standard for Identification of Contact Wire Used in Overhead Contact Systems Published By Publication…
-
IEEE 1815-2012
IEEE Standard for Electric Power Systems Communications-Distributed Network Protocol (DNP3) Published By Publication Date Number…
-
IEEE 1815-2012
IEEE Standard for Electric Power Systems Communications-Distributed Network Protocol (DNP3) Published By Publication Date Number…
-
IEEE 1057 2017:2018 Edition
IEEE Standard for Digitizing Waveform Recorders Published By Publication Date Number of Pages IEEE 2018…
-
IEEE 1149.4 2011
IEEE Standard for a Mixed-Signal Test Bus Published By Publication Date Number of Pages IEEE…
-
IEEE 1812-2023(Redline)
IEEE Guide for Testing Permanent Magnet Machines (Redline) Published By Publication Date Number of Pages…
-
IEEE 1819-2016
IEEE Standard for Risk-Informed Categorization and Treatment of Electrical and Electronic Equipment at Nuclear Power…
-
IEEE 1516-2010
IEEE Standard for Modeling and Simulation (M&S) High Level Architecture (HLA)– Framework and Rules Published…
-
IEEE 1815-2012
IEEE Standard for Electric Power Systems Communications-Distributed Network Protocol (DNP3) (Superseded Redline) Published By Publication…
-
IEEE 1716 2014
IEEE Recommended Practice for Managing Natural Disaster Impact on Key Electrical Systems and Installations in…
-
IEEE 1861 2014
IEEE Guide for On-Site Acceptance Tests of Electrical Equipment and System Commissioning of 1000 kV…
-
IEEE 1876-2019
IEEE Standard for Networked Smart Learning Objects for Online Laboratories Published By Publication Date Number…
-
IEEE 1856 2017
IEEE Standard Framework for Prognostics and Health Management of Electronic Systems Published By Publication Date…
-
IEEE 1856-2017
IEEE Standard Framework for Prognostics and Health Management of Electronic Systems Published By Publication Date…
-
IEEE 1812-2023
IEEE Guide for Testing Permanent Magnet Machines (Published) Published By Publication Date Number of Pages…
-
IEEE 1516-2010(Redline)
IEEE Standard for Modeling and Simulation (M&S) High Level Architecture (HLA)– Framework and Rules (Redline)…
-
IEEE 1826-2012
IEEE Standard for Power Electronics Open System Interfaces in Zonal Electrical Distribution Systems Rated Above…
-
IEEE 979 2012
IEEE Guide for Substation Fire Protection Published By Publication Date Number of Pages IEEE 2012…
-
IEEE 1815-2012
IEEE Standard for Electric Power Systems Communications-Distributed Network Protocol (DNP3) (Superseded Redline) Published By Publication…
-
IEEE 979-2012(Redline)
IEEE Guide for Substation Fire Protection (Redline) Published By Publication Date Number of Pages IEEE…
-
IEEE 1819 2016:2017 Edition
IEEE Standard for Risk-Informed Categorization and Treatment of Electrical and Electronic Equipment at Nuclear Power…
-
IEEE 1896-2016
IEEE Standard for Identification of Contact Wire Used in Overhead Contact Systems Published By Publication…
-
IEEE 1812-2023
IEEE Guide for Testing Permanent Magnet Machines (Published) Published By Publication Date Number of Pages…
-
IEEE 1812-2014
IEEE Trial-Use Guide for Testing Permanent Magnet Machines Published By Publication Date Number of Pages…
-
IEEE 1812-2023
IEEE Guide for Testing Permanent Magnet Machines (Approved Draft) Published By Publication Date Number of…
-
IEEE 1818 2017
IEEE Guide for the Design of Low-Voltage Auxiliary Systems for Electric Power Substations Published By…
-
IEEE 1812-2023
IEEE Guide for Testing Permanent Magnet Machines (Approved Draft) Published By Publication Date Number of…
-
IEEE 1812 2015
IEEE Trial-Use Guide for Testing Permanent Magnet Machines Published By Publication Date Number of Pages…
-
IEEE 1876 2019
IEEE Standard for Networked Smart Learning Objects for Online Laboratories Published By Publication Date Number…
-
IEEE 1815 2010
IEEE Standard for Electric Power Systems Communications — Distributed Network Protocol (DNP3) Published By Publication…
-
IEEE 1516-2010(Redline)
IEEE Standard for Modeling and Simulation (M&S) High Level Architecture (HLA)– Framework and Rules (Redline)…
-
IEEE 1516 2010
IEEE Standard for Modeling and Simulation (M&S) High Level Architecture (HLA)– Framework and Rules Published…
-
IEEE/ASHRAE 1635 2018
IEEE/ASHRAE Guide for the Ventilation and Thermal Management of Batteries for Stationary Applications Published By…
-
IEEE 1816 2013
IEEE Guide for Preparation Techniques of Extruded Dielectric, Shielded Cables Rated 2.5 kV through 46…
-
IEEE 1815-2010
IEEE Standard for Electric Power Systems Communications — Distributed Network Protocol (DNP3) Published By Publication…
-
IEEE 1810 2017
IEEE Guide for the Installation of Fire-Rated Cables Suitable for Hydrocarbon Pool Fires for Critical…
-
IEEE 2888.1-2023
IEEE Standard for Specification of Sensor Interface for Cyber and Physical Worlds (Published) Published By…
-
IEEE 1826 2012
IEEE Standard for Power Electronics Open System Interfaces in Zonal Electrical Distribution Systems Rated Above…
-
IEEE 1815 2012
IEEE Standard for Electric Power Systems Communications-Distributed Network Protocol (DNP3) Published By Publication Date Number…
-
IEEE 1812-2023(Redline)
IEEE Guide for Testing Permanent Magnet Machines (Redline) Published By Publication Date Number of Pages…
