Shopping Cart

No products in the cart.

IEEE 269a 2012

$35.21

IEEE Standard Methods for Measuring Transmission Performance of Analog and Digital Telephone Sets, Handsets, and Headsets–Amendment 1

Published By Publication Date Number of Pages
IEEE 2012 33
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Amendment Standard – Active. Practical methods for making laboratory measurements of electroacoustic characteristics of analog and digital telephones, handsets, and headsets are presented. The methods may also be applicable to a wide variety of other communications equipment, including cordless, wireless, and mobile communications devices. Measurement results may be used to evaluate these devices on a standardized basis. Application is in the frequency range from 100 Hz to 8500 Hz.

PDF Catalog

PDF Pages PDF Title
1 IEEE Std 269a-2012 Front cover
3 Title page
6 Notice to users
Laws and regulations
Copyrights
Updating of IEEE documents
Errata
Patents
8 Participants
10 Introduction
11 Contents
13 IMPORTANT NOTICE
14 2. Normative references
3. Definitions
4. Test equipment and setup
4.1 Ear simulators
16 6. Test procedure for analog sets
6.5 Send
6.8 Telephone set impedance
7. Test procedures for digital and 4-wire systems
7.2 Digital test circuits
17 7.5 Send
8. Test procedures for analog 4-wire handsets and headsets
8.4 Send
18 Annex E (normative)
Test signals
E.6 Speech-like signals
19 Annex G
(normative) Analysis methods
G.6 Measurement bandwidth
20 Annex J (normative)
Receive level, conversational gain, and frequency response metrics
J.4 Conversational gain
J.5 Tonal balance
23 Annex L (normative)
Distortion
L.3 Pulsed noise signal-to-distortion-and-noise ratio (PN-SDNR)
25 Annex M (normative)
Send signal-to-noise ratio ambient noise reduction and its effects on speech quality
M.1 General
M.2 Overview of metrics
26 M.3 Metrics
28 M.4 Measurement setup and calibration
30 M.5 Collection of signals to be measured
32 M.6 Choice of test signals
IEEE 269a 2012
$35.21