Shopping Cart

No products in the cart.

IEEE 519-2014

$31.96

IEEE Recommended Practice and Requirements for Harmonic Control in Electric Power Systems

Published By Publication Date Number of Pages
IEEE 2014 29
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Revision Standard – Superseded. Goals for the design of electrical systems that include both linear and nonlinear loads are established in this recommended practice. The voltage and current waveforms that may exist throughout the system are described, and waveform distortion goals for the system designer are established. The interface between sources and loads is described as the point of common coupling and observance of the design goals will reduce interference between electrical equipment. This recommended practice addresses steady-state limitations. Transient conditions exceeding these limitations may be encountered. This document sets the quality of power that is to be provided at the point of common coupling. This document does not cover the effects of radio-frequency interference; however, guidance is offered for wired telephone systems.

PDF Catalog

PDF Pages PDF Title
1 IEEE Std 519-2014 Front Cover
3 Title page
5 Important Notices and Disclaimers Concerning IEEE Standards Documents
8 Participants
10 Introduction
12 Contents
13 Important Notice

1. Overview
14 1.1 Scope

1.2 Purpose
15 2. Normative references

3. Definitions
16 4. Harmonic measurements

4.1 Measurement window width
17 4.2 Very short time harmonic measurements

4.3 Short time harmonic measurements

4.4 Statistical evaluation

5. Recommended harmonic limits
18 5.1 Recommended harmonic voltage limits

5.2 Recommended current distortion limits for systems nominally rated 120 V through 69 kV
19 5.3 Recommended current distortion limits for systems nominally rated above 69 kV through 161 kV
20 5.4 Recommended current distortion limits for systems nominally rated about 161 kV
21 5.5 Recommendations for increasing harmonic current limits
23 Annex A (informative) Interharmonic voltage limits based on flicker
25 Annex B (informative) Telephone influence factor (TIF)
27 Annex C (informative) Limits on commutation notches
29 Annex D (informative) Bibliography
IEEE 519-2014
$31.96