IEEE C50.13-2005
$65.54
IEEE Standard for Cylindrical-Rotor 50 Hz and 60 Hz Synchronous Generators Rated 10 MVA and Above
Published By | Publication Date | Number of Pages |
IEEE | 2005 | 60 |
Revision Standard – Superseded. The requirements in this standard are applied to 50 Hz and 60 Hz, two-pole and four-pole, cylindrical-rotor synchronous generators driven by steam turbines and/or by combustion gas turbines. The drive may be direct or through a gearbox or other device that permits different speeds for the turbine and the generator. The generators covered by this standard are to have rated outputs of 10 MVA and above.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std C50.13ā¢-2005, IEEE Standard for Cylindrical-Rotor 50 Hz and 60 Hz Synchronous Generators Rated 10 MVA and Above |
3 | Title page |
6 | Introduction |
7 | Notice to users Errata Interpretations Patents |
8 | Participants |
10 | CONTENTS |
13 | 1. Scope 2. Normative references |
14 | 3. Definitions |
16 | 4. Operational requirements 4.1 Service conditions and steady-state duty |
22 | 4.2 Transient event and emergency duty requirements |
28 | 4.3 Service environment |
29 | 5. Rating and performance characteristics 5.1 Output rating |
30 | 5.2 Capabilities |
31 | 5.3 Voltage and current ratings 5.4 Power factor and reactive power capability |
33 | 5.5 Short-circuit ratio 5.6 Transient and subtransient reactances |
34 | 5.7 Voltage wave shape |
35 | 6. Insulation systems 6.1 Insulation systems defined |
36 | 6.2 Classes of insulation systems 6.3 The use of different classes of insulation systems |
37 | 7. Temperatures and temperature limits 7.1 Temperature limits |
40 | 7.2 Methods of temperature determination |
41 | 7.3 Locations of embedded temperature detectors 7.4 Location of coolant temperature detectors 8. Efficiency 8.1 Methods 8.2 Reference conditions |
42 | 8.3 Types of losses |
43 | 8.4 Test tolerance on losses 9. Tests 9.1 Categories and scope of tests |
45 | 9.2 Test procedural requirements |
47 | 9.3 Heat exchanger testing 9.4 Testing high-voltage terminal bushings 9.5 Overspeed testing 10. Marking 10.1 Nameplate |
48 | 10.2 Information about other output capabilities 10.3 Other information about the unit 10.4 Other marking |
49 | Annex A (informative) Bibliography |
51 | Annex B (informative) Guide for the basic specification of generators B.1 Introduction B.2 Sources of requirements |
57 | B.3 Expanded discussions of selected requirements |
59 | Annex C (normative) TIF weighting factors |