This part of IEC 61969 contains design guidelines for outdoor enclosures for electrical and electronic equipment and is applicable over a wide field of mechanical, electromechanical and electronic equipment and its installation where a modular design is used. The objectives of this document are: – to provide an overview of specifications for enclosures focused on requirements for outdoor applications for stationary use at non-weather protected locations, and – to achieve product integrity under outdoor conditions and to ease product selection for the sourcing of outdoor enclosures from different vendors. These enclosures are considered to contain any equipment and provide protection for the outdoor installed facilities against unwanted environmental impacts. The installed equipment can be, but is not limited to, subracks or chassis according to IEC 60917 (all parts) or IEC 60297 (all parts). A typical outdoor enclosure is shown in Figure 1. [Figure 1]<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 2<\/td>\n | undefined <\/td>\n<\/tr>\n | ||||||
| 5<\/td>\n | Annex ZA (normative)Normative references to international publicationswith their corresponding European publications <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | Blank Page <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | English CONTENTS <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | FOREWORD <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | INTRODUCTION <\/td>\n<\/tr>\n | ||||||
| 13<\/td>\n | 1 Scope Figure 1 \u2013 Typical outdoor enclosure <\/td>\n<\/tr>\n | ||||||
| 14<\/td>\n | 2 Normative references <\/td>\n<\/tr>\n | ||||||
| 15<\/td>\n | 3 Terms and definitions <\/td>\n<\/tr>\n | ||||||
| 16<\/td>\n | 4 Coordination dimensions 5 Environmental requirements, tests and safety aspects 5.1 Classification of environmental conditions Figure 2 \u2013 Locations of outdoor enclosures <\/td>\n<\/tr>\n | ||||||
| 17<\/td>\n | Table 1 \u2013 Operating and transportation conditions <\/td>\n<\/tr>\n | ||||||
| 18<\/td>\n | 5.2 Transportation and installation related mechanical loads 5.3 Operational related mechanical loads 5.4 Static load capacity Table 2 \u2013 Safety aspects <\/td>\n<\/tr>\n | ||||||
| 19<\/td>\n | 5.5 Seismic performance 6 Electromagnetic shielding 7 Thermal management and acoustic noise emission <\/td>\n<\/tr>\n | ||||||
| 20<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Mechanical structures for electrical and electronic equipment. Outdoor enclosures – Design guidelines<\/b><\/p>\n |