Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BSI PD CEN/TS 14758-2:2016

BSI PD CEN/TS 14758-2:2016

$142.49

Plastics piping systems for non-pressure underground drainage and sewerage. Polypropylene with mineral modifiers (PP-MD) – Guidance for the assessment of conformity

Published By Publication Date Number of Pages
BSI 2016 26
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This Technical Specification gives guidance for the assessment of conformity of materials, products, joints and assemblies in accordance with the applicable part(s) of EN 14758 intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of certification procedures.

NOTE In order to help the reader, a basic test matrix is given in Annex A.

In conjunction with EN 14758-1 this document is applicable to solid wall piping systems made of polypropylene modified with mineral(s) (PP-MD) intended to be used for:

  • non-pressure underground drainage and sewerage outside the building structure (application area code “U”); and

  • non-pressure underground drainage and sewerage for both buried in ground within the building structure (application area code “D”) and outside the building structure.

This is reflected in the marking of products by “U” and “UD”.

PDF Catalog

PDF Pages PDF Title
5 European foreword
6 Introduction
Figure 1 — Typical scheme for the assessment of conformity by a manufacturer
Figure 2 — Typical scheme for the assessment of conformity by a manufacturer, including certification
7 1 Scope
2 Normative references
3 Terms and definitions
10 4 Abbreviated terms
11 5 General
6 Testing and inspection
6.1 Material specification
6.2 Grouping
6.2.1 General
6.2.2 Size groups
Table 1 — Size groups
12 6.2.3 Fitting groups
Table 2 — Fitting groups
6.3 Type testing
13 Table 3 — Characteristics of pipes that require type testing (TT)
14 Table 4 — Characteristics of fittings that require type testing (TT)
15 Table 5 — Characteristics of fitness for purpose of the system that require type testing (TT)
6.4 Batch release tests
16 Table 6 — Characteristics of pipes and minimum sampling frequencies for BRTs
Table 7 — Characteristics of fittings and minimum sampling frequencies for BRTs
17 6.5 Process verification tests
Table 8 — Characteristics of pipes and minimum sampling frequencies for PVTs
Table 9 — Characteristics of fittings and minimum sampling frequencies for PVTs
18 Table 10 — Characteristics for fitness for purpose and minimum sampling frequencies for PVTs
6.6 Audit tests
Table 11 — Characteristics of pipes and minimum sampling frequencies for ATs
20 Table 12 — Characteristics of fittings and minimum sampling frequencies for ATs
Table 13 — Characteristics for fitness for purpose of the system and minimum sampling frequencies for ATs
6.7 Indirect tests
21 6.8 Test records
22 Annex A (informative) Basic test matrix
Table A.1 — Basic test matrix
23 Bibliography

Related products

BSI PD CEN/TS 14758-2:2016
$142.49