ASTM-A778 2009

$35.75

A778-01(2009)e1 Standard Specification for Welded, Unannealed Austenitic Stainless Steel Tubular Products

Published By	Publication Date	Number of Pages
ASTM	2009	4

Guaranteed Safe Checkout

Categories: 23.040.40 - Metal fittings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers straight seam and spiral butt seam welded unannealed austenitic stainless steel tubular products intended for low and moderate temperatures and corrosive service where heat treatment is not necessary for corrosion resistance. Table 1 lists the five grades covered by this specification. The user of this specification should be aware that a minimum amount of testing and examination is required of the basic product. The user requiring additional testing or examination is referred to the supplemental requirements or Ordering Information, or both. Users requiring a tubular product with post-weld heat treatment or with radiographic examination are referred to Specification A 312/A 312M , A 358/A 358M , or A 409/A 409M , as applicable.

1.2 This specification covers welded unannealed tubular products 3 in. (75 mm) through 48 in. (1200 mm) in outside diameter and in nominal wall thicknesses of 0.062 in. (1.5 mm) through 0.500 in. (12.5 mm) produced to this specification. Tubular products having other diameters or wall thickness, or both, may be furnished provided it complies with all other requirements of this specification.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

TABLE 1 Chemical Requirements

^A New designation established in accordance with Practice E 527 and SAE J1086.

^B The carbon analysis shall be reported to the nearest 0.01 %, except for the low carbon (0.030) types, which shall be reported to the nearest 0.001 %.

^C The titanium content shall be not less than five times the carbon content and not more than 0.70 %.

^D The columbium plus tantalum content shall be not less than ten times the carbon content and not more than 1.10 %.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Ordering Information Significance and Use Manufacture Mechanical Test Requirements TABLE 1
3	Heat Treatment Chemical Requirements Permissible Variations in Tubular Products Dimensions Workmanship Inspection Rejection Certification Product Marking Packaging Keywords TABLE 2